Gemm WL5/226P Инструкция по эксплуатации онлайн [54/122] 279080

WL5/1-2 Rev.00 05-2013 pag. 54

7.7 – USE

- To activate the keypad press any key for 3 seconds, then you can view and change the set point, if necessary;

press the key just once to display the set temperature, which can be changed using the up and down

arrow keys by pressing and holding for 3 sec the same key.

- With the keypad active, a manual defrost can be selected; press and hold for 3 sec the key and if the

evaporator temperature is no higher than +8°C, a manual defrost phase is activated. This phase ends either

when the time of 20’ has elapsed or when the temperature measured by the evaporator sensor is (+8°C). The

automatic defrost, managed by the controller, takes place once every 12H for a max. of 20’ during which time

the readout dEF is shown on the display.

- With the keypad active, press keys and just once to display the maximum and minimum

temperature respectively, which are recorded by the sensor inside the cabinet. The displayed values are

preceded by the readouts LO and HY respectively. To reset this stored value, press and hold for 3sec the

key at the time it is displayed. On the display this reset is preceded by the readout RST (reset).

7.7.1 – SPECIAL USE

- With the keypad active, press and hold for 3 sec the key to activate the CONTINUOUS CYCLE phase.

This phase lasts (1H) at a temperature (+4°C). These values are factory set in the controller. Unlike the normal

refrigerating phase, in this case the symbol on the display is lit. When the set time (1H) has elapsed, the

symbol will go out and the appliance will start once again to operate with the previous set point.

7.7.2 – STOPPING FOR LONG PERIODS

With the appliance OFF and the keypad active, press the key and pull the plug out of the socket.

Thoroughly clean the appliance (as described under 8.2) and make sure the door is left ajar at the end of cleaning and

remains ajar for the entire period that the appliance is not used.