Gemm BCT/05 (встр. агрегат) Инструкция по эксплуатации онлайн [89/138] 279081

BCT_T Rev.00 05-2015 pag. 89

6 – SETTING UP

AFTER INSTALLING THE APPLIANCE, WAIT AT LEAST TWO HOURS BEFORE TURNING IT ON.

6.1 – CONNECTIONS

6.1.1 – ELECTRICAL CONNECTION

Electrical connection must be made by a specialised electrician.

 Check that the power supply voltage given on the ID plate corresponds to that available at the

installation site.

 Connections must be made to current regulations; the supply mains must have an efficient

earthing system compliant with electricity regulations in the country; this is a responsibility of

the customer.

 Do not make tight bends on the power lead and do not place any object whatsoever on top of it.

If it is necessary to unplug the mains supply, first make sure the circuit board is on OFF on

the display.

The manufacture declines all responsibility for damage or accidents caused by failure to observe

such regulations.

ELECTRICAL CONNECTION PROCEDURE

The appliance is supplied by the manufacturer complete with power plug. Just connect the power plug to a socket at the

installation site; the system must be carried out to current regulations.

The electricity supply at the installation site must have the following requisites:

 Voltage: 230 Vac

 Frequency: 50 Hz

6.2 – PRELIMINARY CHECKS

The electrician fitter shall train the operator in the correct use of the blast chiller and give the basic notions of

maintenance.

METHOD

The operations to prepare the blast chiller for initial start-up must be carried out by a specialised engineer, in the

presence of the operator, who can acquire information to carry out certain routine maintenance and cleaning.

Before starting up the appliance, a series of checks and inspections must be carried out for the purpose of preventing

errors or accidents during start-up.

 Check that the appliance has not been damaged during transport.

 Check with special care for any damage to the electrical box, push button control panel, wiring and pipes.

 Check that all external power sources have been connected properly.

 Check that the machine is perfectly level.

6.2.1 – REGULATION

Regulation carried out by unauthorized personnel may damage the appliance and expose the

operator to serious hazards. Regulation carried out by unauthorized personnel is considered

tampering with the appliance and as such null the warranty and relieve the manufacturer of any

responsibility.