Mitsubishi Electric SLZ-KF50VA / SUZ-KA50VA5 [5/28] Parts names
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Mitsubishi Electric SLZ-KF50VA / SUZ-KA50VA5 [5/28] Parts names

Mitsubishi Electric SLZ-KF35VA / SUZ-KA35VA5 [5/28] Parts names
5
■ Wireless Remote-Controller [SLZ-KA·VAL3 only]
■ Outdoor unit
Power
Earth
Indoor-Outdoor
Connection wire
Ref. Pipes
2. Parts Names
Note (Only for wireless remote controller):
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately two minutes after power is sup-
plied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
■ The indoor unit beeps to confi rm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such
as fl uorescent lights and strong light can affect the ability of the indoor unit to receive sig-
nals.
■ If the operation lamp near the receiver on the indoor unit is fl ashing, the unit needs to be
inspected. Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote control-
ler on a wall and be sure to always place the remote controller in the holder after use.
Battery installation/replacement
[SLZ-KA·VAL3 only]
1. Remove the top cover, insert two AAA batteries,
and then install the top cover.
Top cover
2. Press the Reset button.
AUTO
COOL
DRY
HEAT
FAN
VANE
SELECT
TIME
Two AAA batteries
Insert the negative (–)
end of each battery
first. Install the bat-
teries in the correct
directions (+, –)!
Press the Reset button
with an object that has
a narrow end.
ON/OFF
RESET
TO O
WARM
TO O
COOL
MODE
AUTO COOL
DRY
HEAT
FAN
VANE
SELECT
TIME
h
ON / OFF button
Pushing button starts operation.
Pushing again stops operation.
MODE SELECT button
This button is used to change
between auto, cooling, heating
and drying operation modes.
TIMER SELECT button
Used for selecting timed starting
or stopping.
FAN SPEED button
This button is used to set fan
speed to low, medium or high.
VANE CONTROL button
Used to change the airfl ow direc-
tion.
SET TEMPERATURE button
SET TEMPERATURE button
sets and any desired room
temperature.

Содержание

Похожие устройства

Скачать