MCZ Pulsar [19/27] Installation and assembly

INSTALLATION AND USE MANUAL

Chapter 4

page

Installation and assembly

4. INSTALLATION AND ASSEMBLY

IMPORTANT!

The stove must be installed and connected to the

chimney flue by specialised technicians or skilled

personnel so that every local or national regulation is

met and, in any case, in accordance with regulation

UNI 10683 REV.

When the stove and frame is unpacked, make sure all parts are in

perfect working order and check for damages due to transport.

If the stove is installed in a place that is difficult to access, the weight

can be reduced by removing internal elements in the furnace. Please

remember to correctly reassemble all elements.

4.1. PREPARATION AND UNPACKING

Open the packaging, remove the brackets, remove the stove from the

platform and position it in the selected area making sure it meets that

foreseen.

The stove must always be kept upright and exclusively moved with a

trolley. Pay careful attention that the door and its glass are protected

from mechanical collisions that could jeopardise their integrity.

Moving the product must always be done with care. If possible, unpack

the stove in the area where it is to be installed.

Packaging material is non-toxic, therefore it does not require special

disposal.

The end use must store, dispose or recycle packaging material in

accordance with local regulations.

4.2. POSITIONING

Always assess the static conditions of the floor that will hold the weight.

If the rear wall is made of flammable material, insulate it and

place the stove at least 30 cm from the wall. Lateral insulation

must reach at least 50 cm from the right, left and top corners.

If the stove is installed on a flammable floor,

adequate insulation is recommended.

Heat sensitive or flammable parts and objects cannot

be stored near the stove: keep these object or parts

at least 100 cm away from the most protruding stove

part.

Stove packaging example

1000

500