Liebherr FKv 4113 белый [4/7] Appliance dimensions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Liebherr FKv 4113 белый [4/7] Appliance dimensions

Liebherr FKv 4113 белый [4/7] Appliance dimensions
10
Setting up
• Donotplacetheapplianceindirectsunlightornearcookers,
radiators and similar sources of heat.
• Theflooronwhichtheappliancestandsshouldbehorizontal
andlevel.Compensateforunevenfloorswiththeadjustable
feet.
•
Donotcoverventilationopeningsor
grille.
• Standard EN378 specifies that the room in
which you install your appliance must have a
volume of 1 m
3
per 8 g of R 600a refrigerant used
in the appliance, so as to avoid the formation
of inflammable gas/air mixtures in the room
where the appliance is located in the event of
a leak in the refrigerant circuit. The quantity of
refrigerant used in your appliance is indicated
on the type plate on the inside of the appliance.
• Alwaysinstalltheappliancedirectlyagainstthewall.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Donotconnecttheapplianceusinganexten-
sion cable or extension socket.
Donotusestand-aloneinverters(conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
Appliance dimensions
Switching the appliance on and o
You are recommended to clean the interior of the appliance before
switchingitonforthersttime(seeCleaning).
Switching the appliance on
Connecttheappliancetothemains-theapplianceisswitchedon.
Switching the appliance o
Pull out the mains plug or set the
temperature control to 0.
Important
When the temperature control is turned to "0", the refrig-
eration system is switched o, but the appliance is not
completely disconnected from the mains.
Before cleaning, always disconnect the appliance from the
mains. Remove the plug.
Setting the temperature
Set the temperature inside the appli-
ance using the temperature control.
The nearer the temperature control
is to the max. setting, the colder the
interior temperature.
Set the control between "0" and "max."
as required.
A B C D E
FKv 26.. 1250 mm 600 mm 610 mm 650 mm 1180 mm
FKv 36.. 1640 mm 600 mm 610 mm 650 mm 1180 mm
FKv 41.. 1800 mm 600 mm 610 mm 650 mm 1180 mm
FKv 54.. 1640mm 750mm 730mm 850mm 1410mm
Temperature display
The thermometer is lo-
cated in the upper part of
the door.
The temperature display
is powered by a battery
which is available from your
specialist dealer.
Changing the battery
• Openthedoor.
• DetachcoverA.
• PulloutthermometerT.
• Openthebatterycompartmentusinga
small screwdriver.
• Replacethebattery.
• Closethebatterycompartment.
• Re-installallparts.
If Er or HH appears in the display, the appliance has a fault.
Consult the customer service department indicating the fault
number displayed.

Содержание

Похожие устройства

Скачать