Lincat D5R/125B [19/20] Cleaning and maintenance

IS517

Page 19

CLEANING AND MAINTENANCE

CLEANING

Disconnect the unit from the electricity supply. Use a mild detergent in

hot water and a soft cloth. Do not use abrasive creams or scourers.

Remove the rear doors, shelves and base panels. Shelves (including

supports) and base-panels may be washed in a dishwasher.

MAINTENANCE

Regular cleaning of the unit is recommended. No other regular maintenance is

required, but it may be necessary to clean the condenser or replace a light tube.

CLEANING THE CONDENSER

Disconnect the unit from the electricity supply.

For counter top models the condenser is located behind a grille on the operator

side of the appliance. Access the condenser by removing the screw holding the

grille in place using the Allen key provided. Use a vacuum cleaner to suck any

debris from the face of the condenser and replace the grille.

For drop in models the condenser is located at the front of the drop in module

and can be brushed down using a stiff bristled brush.

REPLACING THE LIGHT

Disconnect the unit from the electricity supply.

Remove doors. Unclip the end caps from the light unit. Remove the diffuser

from its clips. To remove the tube, carefully rotate it 90

and slowly pull down

until it is released. It is recommended that the starter (a round cylinder located

at one end of the tube) is also replaced at the same time. To remove the starter,

rotate it anticlockwise. Fitting the new tube is the reverse of the above

sequence.