Dune HD Connect WE [13/28] Nas network attached storage

English

Switching the Player On and Off

To put the player into the standby mode, press the «POWER» RC button. To exit the standby mode, press this buttons

again.

Depending on the player settings (see the player setup menu), the «hardware standby» or «software standby» mode

may be used. In the «hardware standby» mode, almost complete power-off takes place and the player consumes

almost no power. In the «software standby» mode, the player produces no signal on the video output, but is still

functioning. For example, if you have some storage devices connected to the player, you may still access them from

network («NAS» function of the player). Exiting the «software standby» mode takes just a few seconds. When the

player is in the «software standby» mode, it still consumes significant power. It is not recommended to keep the player

in the «software standby» mode for a while if you do not need it. To switch the player off completely, press and hold

«POWER» button for a couple of seconds or disconnect the power plug.

NOTE: After switching off the player completely or putting the player into the «hardware standby» mode, it is

recommended to wait about 1 minute before switching it on again.

NAS (Network Attached Storage)

You can access storage devices connected to the player from the local network using FTP and SMB protocols. On a

Windows PC, just type «ftp://ip_address» or «\\ip_address» in the Windows explorer, where «ip_address» is the IP

address of the player.

Wi-Fi

If you player is equiped with built-in Wi-Fi adapter, you can use it to connect the player to the local network via Wi-Fi.