Hama EWS-820 Инструкция по эксплуатации онлайн [7/138] 297900

6.1. Initial settings

•After inserting the batteries, avalue indicating the height in metres (15) will ash.

•Set the following information in the order listed:

•height of the location, symbol for the current weather conditions, atmospheric pressureunit (hPa/ inhg)

•Toselect the individual values, press the +button (27) or the –button (28) and conrm each selection by

pressing the HISTORY button (29). .

•The standardsettings areretained if you do not make an entry within 20 seconds. Youcan subsequently

change/reset these values at any time as described in 6.4. Basic and manual settings.

6.2. Connection to the measuring station

•After making initial settings, the base station automatically searches for aconnection to the measuring

station and performs initial setup.

Note

•Initial setup takes approx. 3minutes.

•Donot press any buttons during setup. Otherwise, values may not be transmitted correctly and thereisa

risk of value errors and inaccuracies.

•The setup process is completed when the indoor (9, 10) and outdoor (18, 20) measurement data is

displayed.

•Ifthe base station still does not receive asignal from the measuring station, press and hold the CHANNEL

button (30)for approx. 3seconds to start the manual search for the signal.

6.3. Selecting the channel/other measuring stations

Note

Youcan install two moremeasuring stations in addition to the included measuring station. Ensurethat the

base and measuring stations areset to the same channel.

Visit www.hama.com for suitable measuring stations.

•Press the CHANNEL button (30)repeatedly to set the channel to that set on the respective measuring

station –see 4.1. Measuring station . 1, 2, 3 (23) or Channel overview

(18) is displayed.

•The base station now shows the data measured (18, 20) on the selected measuring station (23).

•Select Channel overview

(18) to show the measurement values of the individual measuring stations/

channels consecutively for 5seconds each.

6.4. Basic and manual settings

Automatic setting using the DCF signal

•After the rst time the base station is switched on and successful transmission is established between the

base station and the measuring station, the clock will automatically search for aDCF signal. During the

search, the wireless symbol (5) will ash.