Sinbo SSI 2864 2200Вт коричневый Инструкция по эксплуатации онлайн [11/59] 298275

- 10 -

Spray

1. The spray can be used in any position, either in dry or steam ironing, as long as the water

tank is filled with water.

2. Press the spray button for this function

NOTE: This button has to be pressed repetitively to start this function for the first time.

Shot of steam

Shot of steam give extra steam for removing persistent wrinkles.

1. Place the temperature selector at the “max”position and wait until the pilot light goes out

2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.

NOTE: For the best steam quality, do not use more than three successive bursts each time.

Several pumping actions are needed to start this function.

Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before

operating the shot of steam control

Cleaning

1. Disconnect the appliance from the mains, before cleaning.

2. Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.

Defects and repairs

Do not attempt to replace a defective mains lead. The appliance has to be returned to an

authorized service centre for repair.

Faults-reasons and solutions

Iron emits an odor or smoke

Iron gives off an odor when turned on for the first time. Oils used during manufacture need to

be burnt off allow ten minutes for odor to disappear.

Iron does not heat

The iron should be plugged into a 230Volt, AC electrical outlet only. The temperature dial must

be set at the desired temperature.

Iron does not steam

The water tank many be empty. Turn the steam valve to “0” and add water .Allow the iron to

heat, and then set the steam dial to the steam setting.

Burst of steam feature does not work

The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should

be in the horizontal position. Prime pump briefly. Allow a short pause between shots. Be sure

to fully depress the burst of steam button.

Spray mist feature does not work

The water tank must be at least 1/4 full. Fill the iron as described in the section “how to fill the

water tank”.

Iron is leaking

The variable steam dial must be set on ” “,until the iron is hot . The temperature setting is too

low to produce steam. Shot of steam used too much, allow iron to re-heat.