Candy CGM 61W-07 [11/18] English
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Candy CGM 61W-07 [11/18] English

Candy CGM 91N-07 [11/18] English
- 11 -
ENGLISH
GB
GENERAL
1.1 Carefully read the following important information
regarding installation safety and maintenance. Keep this
information booklet accessible for further consultations. The
appliance has been designed for use in the ducting version (air
exhaust to the outside – Fig.1B), filtering version (air circulation
on the inside – Fig.1A) or with external motor (Fig.1C).
SAFETYPRECAUTION
2.1 Take care when the cooker hood is operating simultane-
ously with an open fireplace or burner that depend on the air
in the environment and are supplied by other than electrical
energy, as the cooker hood removes the air from the environ-
ment which a burner or fireplace need for combustion. The
negative pressure in the environment must not exceed 4Pa
(4x10-5 bar). Provide adequate ventilation in the environment
for a safe operation of the cooker hood.Follow the local laws
applicable for external air evacuation.
2.2Beforeconnectingthemodeltotheelectricitynet-
work:
- Control the data plate (positioned inside the appliance)
to ascertain that the voltage and power correspond to the
network and the socket is suitable. If in doubt ask a qualified
electrician.
- If the power supply cable is damaged, it must be replaced
with another cable or a special assembly, which may be
obtained direct from the manufacturer or from the Technical
Assistance Centre.
- This device must be connected to the mains supply through
either a plug fused 3A or hardwired to a 2 phase spur protected
by 3A fuse.
2.3Warning!
Incertain circumstances electricalappliancesmaybea
dangerhazard.
A)Donotcheckthestatusofthefilterswhilethecooker
hoodisoperating.
B)Donottouchbulbsoradjacentareas,duringorstraight
afterprolongeduseofthelightinginstallation.
C)Flambècookingisprohibitedunderneaththecooker
hood.
D)Avoidfreeflame,asitisdamagingforthefiltersanda
firehazard.
E)Constantlycheckfoodfrying toavoidthatthe over-
heatedoilmaybecomeafirehazard.
F)Disconnecttheelectricalplugpriortoanymaintenance.
G)Thisapplianceisnotintendedforusebyyoungchildren
orinfirmpersonswithoutsupervision.
H)Youngchildrenshouldbesupervisedtoensuretheydo
notplaywiththeappliance
I)Thereshallbeadequateventilationoftheroomwhen
therangehoodis usedatthesame timeas appliances
burninggasorotherfuels.
L)Thereisariskoffireifcleaning isnot carriedoutin
accordancewiththeinstructions.
2.4 This appliance conforms to the European Directive
EC/2002/96, Waste Electrical and Electronic Equipment
(WEEE). By making sure that this appliance is disposed of in
a suitable manner, the user is helping to prevent potential
damage to the environment or to public health.
The symbol on the product or on the accompanying
paperwork indicates that the appliance should not be
treated as domestic waste, but should be delivered to
a suitable electric and electronic appliance recycling
collection point. Follow local guidelines when disposing of
waste. For more information on the treatment, re-use and
recycling of this product, please contact your local authority,
domestic waste collection service or the shop where the ap-
pliance was purchased.
INSTALLATION INSTRUCTIONS
3.1Assemblyandelectricalconnectionsmustbecarried
outbyspecialisedpersonnel.
3.2Wear protectiveglovesbeforeproceedingwiththe
installation.
3.3ElectricConnection:
- The appliance has been manufactured as a class II, therefore
no earth cable is necessary. The plug must be easily acces-
sible after the installation of the appliance. If the appliance
is equipped with power cord without plug, a suitably di-
mensioned omnipolar switch with 3 mm minimum opening
between contacts must be tted between the appliance and
the electricity supply in compliance with the load and current
regulations.
- The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral.
3.4 The minimum distance between the support surfaces
of the cooking pots on the cooker top and the lowest part
of the cooker hood must be at least 65cm. If a connection
tube composed of two parts is used, the upper part must be
placed outside the lower part. Do not connect the cooker
hood exhaust to the same conductor used to circulate hot air
or for evacuating fumes from other appliances generated by
other than an electrical source. Before proceeding with the
assembly operations, remove the anti-grease lter(s) (Fig.7)
so that the unit is easier to handle.
- In the case of assembly of the appliance in the suction version
prepare the hole for evacuation of the air.
3.5 We recommend the use of an air exhaust tube which has
the same diameter as the air exhaust outlet hole. If a pipe with
a smaller diameter is used, the eciency of the product may
be reduced and its operation may become noisier.
Pleasenote:
If your version of the appliance has decorative glass before
installing the hood, carry out the following steps as shown
in gure4:
1 - Remove both the cooker hood body B and the glass
panel A from the packaging and place them horizontally on
a secure surface.
2 - Take the glass panel A and position it above the cooker
hood body B.
3 - Fix the glass panel securely to the cooker hood body using
the 4 sleeves C and 4 screws D as indicated.
•Fixingtothewall
Drill the holes A respecting the distances indicated (Fig.2). Fix
the appliance to the wall and align it in horizontal position
to the wall units. When the appliance has been adjusted,
denitely x the hood using the screws A (Fig.5). For the

Содержание

Похожие устройства

Скачать