BVItech BV-61BKM [12/16] Getting started
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

BVItech BV-61BKM [12/16] Getting started

BVItech BV-61BKM [12/16] Getting started
EN 12
BV-61
Caution: The normal function of the product may be disturbed under the
environment with electrostatic discharge. If so, simply reset the product to
resume normal operation by following the instruction manual. In case the
function could not resume, please use the product in other location.
Note: This LED weather station must work with the adapter. If the user
removes the adaptor, the LED weather station will turn off the display,
save the last reading of the temperature and weather forecast; keep
running the internal clock with the backup battery. The LED weather
station will start RF searching mode for 2 minute after plug in the adaptor.
Pic. 2 Wireless outdoor sensor
2. Battery installation and RF registration for remote sensor
1. Open the battery compartment at the bottom of the outdoor sensor
(see picture 2);
2. Install 2 pieces of AA size batteries according to the polarity mark inside;
3. Close the battery compartment of outdoor sensor;
4. The transmission LED on the front of the outdoor sensor will start to
ash for 10 seconds. The default ashing frequency is once per around 2
seconds to indicate this sensor will be registered on channel 1 if not set
manually within 10 seconds;
5. While the transmission LED is ashing, press once the [CH] button
at
the bottom of a remote sensor and it will ash twice per around 2 seconds
to indicate this sensor will be registered on channel 2. Keep toggle on [CH]
button can change channel setting up to 3 and then back to channel 1.
Note: Replace the batteries when the low battery indicator in the channel appears.
3. Backup battery installation for main unit
In the event that the AC/DC adaptor power is disconnected or a power failure
or other interruptions occur, the backup batteries will maintain the time, weather
and alarm settings. The light will resume working when AC power is restored.
DESCRIPTION OF BUTTON
The LED weather station has 8 buttons on rear side.
1. [
%
] button
- Press once to switch from clock mode to alarm time display mode;
- While in alarm display mode, press once to toggle between enable or
disable the daily alarm;
- While in alarm display mode, press and hold for 2 seconds to enter alarm
setting mode.
2. [MAX/MIN] button
- Toggle to display the Max/Min reading of the Indoor & Remote Temperature;
- Press & hold for 2 seconds to clear the memorized Max/Min readings of
the Indoor channel or the selected remote channel.
3. [MENU/SETUP] button
- Press and hold 2 seconds to enter clock setting mode.
4. [CH] button
- Select among channel 1, 2, 3 or to enter auto scroll mode;
- Press and hold for 2 seconds to activate or deactivate the sensor
searching mode.
5. [
▲] button
- Press once to increase the setting in CLOCK or ALARM setting mode.
6. [
▼] button
- Press once to decrease the setting in CLOCK or ALARM setting mode.
7. [RESET] button
Press once to trigger system reset and restore the factory default setting.
8. [BRIGHT/DIM] button
Toggle to select a bright LED display or a dim LED display.
GETTING STARTED
1. Easy set up
This unit was designed for easy set up. For best operation, the following
steps are required to be done in the proper sequence.
1. Insert batteries to the remote sensor and set it to desired channel by
pressing [CH] button;
2. Insert backup batteries to the main unit;
3. Power on AC/DC adapter and insert the plug into Adaptor Connection [N]
of the weather station;
4. The main unit will show the temperature reading of the remote sensor in
corresponding channel if it receives the RF signal and registers the remote
sensor successfully.

Содержание

Похожие устройства

Скачать