Ryobi DRILLDRIVER LLCDI18-LL99X 5133002482 [9/153] English

Ryobi DRILLDRIVER LLCDI18-LL99X 5133002482 [9/153] English
4
English
GB
FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR
OPERATION
TORQUE ADJUSTMENT
When using the drill-driver for various driving applications,
it becomes necessary to increase or decrease the torque
in order to help pre vent the possibility of damaging
screw heads, threads, workpiece, etc. In gener al, torque
intensity should correspond to the scre
torque is too high or the scre
w diameter. If the
may be damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
The torque is g reater when the torque adjustment r
is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
The proper setting depends on the type of mater
ing
ws too small, the screws
the size of screw you are using.
BIT STORAGE
When not in use, bits provided with the drill can be placed
in the storage areas located on the base of the drill.
ial and
WARNING:
Make sure to inser
chuck jaws. Do not inser
t the dr ill bit str aight into the
chuck jaws at an angle then tighten. This could
cause the dr ill bit to be thro wn from the dr ill,
resulting in possib le serious personal injur y or
damage to the chuck.
NOTE: Rotate the chuc k body in the direction of the
arrow mar ked LOCK to tighten the chuc
t the dr ill bit into the
use a wrench to tighten or loosen the chuck jaws.
REMOVING BITS
Lock the switch trigger by placing the rotation selector
in the center position.
Open the chuck jaws.
NOTE: Rotate the chuc k body in the direction of the
arrow marked UNLOCK to loosen the chuck jaws. Do
not use a wrench to tighten or loosen the chuck jaws.
Remove the drill bit.
DRILLING
Check the rotation selector f
k jaws. Do not
(forward or reverse).
Secure the mater ial to be dr illed in a vise or with
clamps to keep it from turning as the drill bit rotates.
Hold the drill firmly and place the bit at the point to be
drilled.
See Figure 8.
or the correct setting
INSTALLING BITS
Lock the switch trigger by placing the rotation selector
in the center position.
Open or close the chuc
opening is slightly larger than the bit siz
k jaws to a point where the
to use. Also, raise the front of the dr ill slightly to k eep
the bit from falling out of the chuck jaws.
Insert the drill bit.
Tighten the chuck jaws on the drill bit.
See Figure 8.
e you intend
See Figure 2.
See Figure 7.

Содержание

Похожие устройства

Скачать