Hitachi H45MRY-NA [5/45] English

Hitachi H45MRY-NA [5/45] English
4
English
PRECAUTIONS ON USING DEMOLITION
HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
4. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
5. Even when the switch is on, the motor is running
and the tool head is pressed to the demolition
surface, the hammer sometimes does not start
operating. In these instances, turn the switch off,
press the tool head against the demolition surface
again, and turn the switch on and off. This should
start the demolition hammer operating. Repeat this
procedure for several minutes, and the demolition
hammer will heat, after which it will operate when
switched to ON-LOCK.
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
(2) Bull Point (SDS-max shank) .................................. 1
(3) Side Handle .............................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Crushing
Asphalt Cutting
Surface Roughing
Tamping
Groove digging and edging
Scooping Work
Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
SPECIFICATIONS
Voltage (by areas)* (110V, 230V, 240V)
Power input 950W*
Full-load impact rate 3000min
–1
Weight (without cord, side handle) 5.9 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
(1) Scoop
(1) Rammer
(2) Shank
(1) Cold chisel
Overall length: 280, 400 mm
(1) Cutter
(1) Bull Point
Overall Length: 280, 400 mm
(1) Bushing Tool
(2) Shank

Содержание

Скачать