Hitachi CS30EHNB [8/34] Operating procedures
![Hitachi CS30EH [8/34] Operating procedures](/views2/1081626/page8/bg8.png)
GB-7
G
B
The chain saw is equipped with a two-
stroke engine. Always run the engine on
fuel, which is mixed with oil.
Provide good ventilation, when fueling or
handling fuel.
Fueling
WARNING! (Fig.2-1B)
Always shut off the engine before refuel-
ing.
Slowly open the fuel tank (1), when filling
up with fuel, so that possible over-
pressure disappears.
Tighten the fuel cap carefully, after fuel-
ing.
Always move the unit at least 3 m (10 ft.)
from the fueling area before starting.
CAUTION!
Before starting, make sure chain brake is
disengaged (if so equipped) and that the
bar/chain does not touch anything.
1. Set ignition switch (1) to ON position.
* Push priming bulb (5) several times so
that fuel flows through bulb into carburetor.
(If so equipped)(Fig. 2-3)
2. With the safety trigger (2) pressed pull
throttle trigger (4) and push throttle lock (3),
then slowly release the throttle trigger first,
then the safety trigger.
This will lock the throttle in starting position.
(Fig.2-2)
3. Pull choke knob to choked position (4).
(Fig.2-3)
4. Pull recoil starter briskly, taking care to keep
the handle in your grasp and not allowing it
to snap back. (Fig.2-4)
5. When you hear the engine want to start,
return choke lever to RUN position (open).
Then pull recoil starter briskly again.
NOTE!
If engine does not start, repeat procedures
from 2 to 5.
6. After starting engine, pull throttle trigger to
release throttle lock. Then allow the engine
about 2-3 minutes to warm up before
subjecting it to any load.
Fuel (Fig. 2-1)
WARNING!
Fig. 2-1 Fig. 2-1CFig. 2-1B
Fig. 2-2 Fig. 2-3 Fig. 2-4
4. Operating procedures
Before fueling, clean the tank cap area care-
fully, to ensure that no dirt falls into the tank.
Make sure that the fuel is well mixed by shaking
the container, before fueling.
Chain oil (Fig. 2-1B)
Fill up with chain oil (2). Always use good
quality chain oil. When the engine is running,
the chain oil is automatically discharged.
NOTE!
When pouring fuel (1) or chain oil (2) into the
tank, place the unit with cap side up.
(Fig. 2-1B)
ADJUSTMENT OF CHAIN OIL SUPPLY
The chain oil quantity discharged through the
lubrication system is factory adjusted to the
maximum. Adjust the quantity in accordance
with the operating condition.
Turn the adjusting screw (1) counterclockwise
to decrease the quantity and turn it clockwise to
increase the quantity. (Fig.2-1C)
Do not try to turn the screw beyond level marks.
Starting (Fig. 2-2, 3)
WARNING!
When the engine starts with the throttle
lock engaged, the engine speed is high
enough to make the chain rotate.
Always use branded 89 octane unleaded
gasoline.
Use genuine two-cycle oil or use a mix
between 25:1 to 50:1, please consult the oil
bottle for the ratio or HITACHI dealer.
Only for the state of California at 50:1.
If genuine oil is not available, use an anti-
oxidant added quality oil expressly labeled for
air-cooled 2-cycle engine use(JASO FC
GRADE OIL or ISO EGC GRADE). Do not use
BIA or TCW (2-stroke water-cooling type)
mixed oil.
Never use multi-grade oil (10 W/30) or waste
oil.
Always mix fuel and oil in a separate clean
container.
Always start by filling half the amount of fuel,
which is to be used. Then add the whole
amount of oil. Mix (shake) the fuel mixture. Add
the remaining amount of fuel.
Mix (shake) the fuel-mix thoroughly before filling
the fuel tank.
Fuel
F
ig.1-2
F
ig.1-5
m
ly
t
ion
Содержание
- Cs30eh s cs35eh s 1
- Owner s manual ägarhandbok betjeningsvejledning bruksanvisning omistajan opas руководство пользователя 1
- Cs30eh s cs35eh s 2
- Owner s manual 2
- Before using your machine 3
- The engine exhaust from this product contains chemicals known to the state of california to cause cancer birth defects and other reproductive harm 3
- Warning 3
- 5 6 7 11 15 4
- What is what warnings and safety instructions assembly procedures operating procedures maintenance specifications 4
- Since this manual covers several models there may be some difference between pictures and your unit use the instructions that apply to your unit 5
- Throttle trigger 2 throttle trigger lockout safety trigger 3 ignition switch 4 oil tank cap 5 recoil starter 6 front handle 7 fuel tank cap 8 choke control knob 9 priming pump 10 guide bar 11 saw chain 12 chain brake front hand guard 13 attachment point 14 spiked bumper optional 15 chain catcher 16 guide bar cover 17 combi box spanner 18 owner s manual 19 throttle lock 5
- What is what 5
- R unit 6
- Warnings and safety instructions 6
- Assembly procedures 7
- Fig 1 fig 2 fig 1b 7
- Fig 3 fig 4 fig 5 7
- Operating procedures 8
- Fig 4b 9
- Fig 6 fig 5 9
- Fig 2 7b fig 2 7c 10
- Fig 2 7d 10
- Fig 2 7f fig 2 7e 10
- Fig 7g fig 7h 11
- Fig 7j fig 7l fig 7k 11
- Fig 7m fig 7n 11
- Fig 3 1 fig 3 3 fig 3 2 12
- Maintenance 12
- Fig 10 13
- Fig 4 fig 6 13
- Fig 4 1 14
- Fig 4 2 14
- Fig 4 3 14
- Fig 4 4 14
- Fig 4 5 fig 4 6 14
- Fig 7b 15
- Specifications 16
- Cs30eh s cs35eh s 18
- Руководство пользователя 18
- Выхлоп двигателя данного изделия содержит химикаты известные в штате kалифорния как вызывающие рак врождённые дефекты и другой репродуктивный вред 19
- Перед применением нового аппарата 19
- Прeдостeрeжeниe 19
- 6 7 11 15 20
- Заявление о соответствии 20
- Содержание 20
- Что это такое предостережения и инструкции по технике безопасности сборочные операции рабочие операции техобслуживание спецификации 20
- Дроссельное пусковое устройство 2 блокировка дроссельного пускового устройства предохранительное пусковое устройство 3 выключатель зажигания 4 крышка масляного бака 5 возвратный стартер 6 передняя рукоятка 7 крышка топливного бака 8 ручка управления воздушной заслонкой 9 заливной насос 10 направляющая шина 11 пильная цепь 12 цепной тормоз передний щиток для защиты руки 13 узел крепления 14 шипованный буфер по заказу 15 цепной ограничитель 16 кожух направляющей шины 17 кольцевой гаечный ключ combi 18 руководство пользователя 19 дроссельный затвор 21
- Поскольку в этом руководстве описывается несколько моделей возможны различия между рисунками и вашим аппаратом пользуйтесь инструкциями прилагаемыми к вашему аппарату 21
- Пред 21
- Что это такое 21
- Йтесь 22
- Предостережения и инструкции по технике безопасности 22
- Рис 1 рис 2 рис 1b 23
- Рис 3 рис 4 рис 5 23
- Сборочные операции 23
- Ис 2 24
- Ис 5 24
- Рабочие операции 24
- Всегда шипова дереву внезап 25
- Если в реакти вас и в дерева 25
- Не экс рукой образо серьёз держи телу ч напряж если реакти вас в пила б а опил 25
- Пр при эт пила от пилить наибол нижн верхне смысле также 25
- Приме 25
- Рис 4b рис 6 25
- Рис 5 25
- Рис 7 25
- Ис 6 26
- Рис 2 7b рис 2 7c 26
- Рис 2 7d 26
- Рис 2 7f рис 2 7e 26
- Винт 27
- Рис 7g рис 7h 27
- Рис 7j рис 7l рис 7k 27
- Рис 7m рис 7n 27
- Тех 27
- Рис 3 1 рис 3 3 рис 3 2 28
- Техобслуживание 28
- Рис 10 29
- Рис 4 рис 6 29
- Рис 5 29
- Рис 7 29
- Рис 8 29
- Рис 9 29
- Ис 6 30
- Ис 9 30
- Рис 4 1 30
- Рис 4 2 30
- Рис 4 3 30
- Рис 4 4 30
- Рис 4 5 рис 4 6 30
- Рис 7 31
- Рис 7b 31
- Спе 31
- Спецификации 32
Похожие устройства
- Hitachi CG40EYNK Инструкция по эксплуатации
- Hitachi CG36DLR5 Инструкция по эксплуатации
- Hitachi CG18DSDLR4 Инструкция по эксплуатации
- Hitachi CG40EASNB Инструкция по эксплуатации
- Зубр ЗНФЧ-29-2,3-С Инструкция по эксплуатации
- Grinda GFP-50-3,4 Инструкция по эксплуатации
- Bosch GKE 35 BCE 601597603 Инструкция по эксплуатации
- Bosch GKE 40 BCE 601597703 Инструкция по эксплуатации
- Fit ET-250 (80651) Инструкция по эксплуатации
- ТОПОЛЬ ВМ 100 7104 Инструкция по эксплуатации
- ТОПОЛЬ ГМ 24 7025 Инструкция по эксплуатации
- Karcher SDP 7000 1.645-115.0 Инструкция по эксплуатации
- Karcher Barrel IrrigSet 1.645-466.0 Инструкция по эксплуатации
- Skil LiIon F0150755RA Инструкция по эксплуатации
- Efco Artik 56222859 Инструкция по эксплуатации
- Craftsman CRAFTSMAN8897040833 Инструкция по эксплуатации
- Efco MT 350 223308 Инструкция по эксплуатации
- McCulloch ST619619100-62 Инструкция по эксплуатации
- Patriot pT 565WF-15 755302488 Инструкция по эксплуатации
- Patriot PT SB76 732107060 Инструкция по эксплуатации