Home
Главная
FSP
Proline 3/1 10K
Инструкция по эксплуатации Страница: 30

FSP Proline 3/1 10K — настройки защиты и управления выходом источника бесперебойного питания [30/48]

FSP Proline 3/1 30K Инструкция по эксплуатации онлайн [30/48] 319489

 09: Maximum battery discharge time setting

Interface

Setting

Parameter 3:

000~999: Set the maximum discharge time from 0 min to 999

min. UPS will shut down to protect battery if the discharge time

arrives before the battery is under voltage. The default value is

990 min.

DIS: Disable battery discharge protection and backup time will

depend on battery capacity.

 10: Programmable output setting

Interface

Setting

Parameter 3: Set programmable output. You may choose the

following three options:

ON: Programmable output is manually switched on timelessly.

OFF: Programmable output is manually switched off. However, if

UPS restarts, this setting will automatically go to “ATO” status.

ATO: Programmable output is automatically turned on or cut off

according to battery or load status. When the battery voltage is

lower than the setting point, or shutdown time arrives, the

programmable output will be cut off automatically. After the utility

is recovering, the output will turn on automatically. If overload

happens, the programmable output also will be cut off

automatically. If it happens 3 times, the programmable output will

be cut off until it is manually switched on.

 11: Shutdown point for programmable output

Interface

Setting

Parameter 2: 001.

Set shutdown time for programmable output.

Parameter 3: Shutdown time in minutes.

Setting range is from 0 to 300. When shutdown time arrives, the

programmable output terminal will be cut off. The default value is

30 minutes.

Parameter 2: 002

Set shutdown voltage for programmable output.

Parameter 3: Shutdown voltage in V.

Setting range is from 11.2 to 13.6. If the battery voltage is less

than the setting point, the programmable output will be cut off.

The default value is 11.2V.

 12: Neutral loss detection

Interface

Setting

Parameter 2:

N.L: Indicates neutral loss detection function.

Parameter 3:

DIS: Disable the neutral loss detection function. The UPS will not

detect the neutral loss or not.

ATO: The UPS will automatically detect the neutral is lost or not. If

neutral loss is detected, an alarm will be generated, if the UPS is

turned on, it will transfer to battery mode. When neutral is

restored and detected, the alarm will be muted automatically, and

the UPS will go back to normal mode automatically.

CHE: The UPS will automatically detect the neutral loss. If neutral

FSP Proline 3/1 10K — настройки защиты и управления выходом источника бесперебойного питания [30/48]

Содержание

Похожие устройства