Gazer F117 [6/44] Important information

ENG

Important information

Warning!

• Do not insert or remove the SD card when the device is on. This

can lead to the MVR malfunction. Wait for 30 seconds after MVR

shutdown,makesurethatallthelightsareoforatleast10

seconds, and only then safely remove the memory card.

• Set the correct time and date before using the device.

• Use at least 0.5 seconds time interval while pressing control

buttons, this guarantees proper functioning of the device.

• Carefully connect the power supply cable to the device. MVR

power supply cable should not be confused with the radar

detector or navigator power supply cables (those may have

voltage of +12V). A wrong connection may cause MVR failure.

• Donotturnothepowerforatleast20secondsafterthepower

supply cable is connected. This is necessary to help the built-in

battery function correctly.

• If after you have started the car (when the power supply cable

is connected to the MVR), the device failed to switch to the

recording mode automatically, simply unplug the power supply

cable for ten seconds and then try again.

• Use the restart option (by pressing RESET button) in the

following cases:

• power indicator is not on when the power supply cable is

connected;

• the device does not switch from the standby to the recording

or control mode;

• the device fails to function properly.

• Files protected from overwriting by G-sensor or by pressing a

corresponding button are recorded in a loop with a 30% limit

of amount on the memory card. Check the free space left on

your memory card on a regular basis to prevent data loss (this

happens when the memory card is full).