Trotec SP3000 Инструкция по эксплуатации онлайн [11/87] 338817

SP3000

Safety

BA 8034_2.4_EN (12/2016) 11 / 87

www.troteclaser.com

2 Safety

At the time of the development and production of the machine, it was built in accordance with

recognized technological regulations and is therefore considered operationally safe.

However, hazards may arise if the machine is used improperly, operated by untrained personnel or

employed for purposes other than those it was designed for.

The present chapter provides an overview of all important safety considerations necessary to ensure

safe and trouble-free operation of the machine. Other chapters of this manual contain specific safety

instructions which are marked with symbols in order to avert dangers.

2.1 Safety principles

2.1.1 Intended use

The machine described in this manual is intended exclusively for laser cutting, engraving and

marking of non-metal and material according to the intended use of the machine using the

supplied software.

The system must be operated, maintained and repaired only by trained personnel familiar with the

designated field of use and the dangers of the machine!

Operate the machine only in technically flawless condition and when it fully complies with the EC

Machinery Directive.

For material details see chapter “Materials” or contact your local Trotec salesperson or Trotec

technical support.

The intended use of this machine also includes that all personnel involved in installation, set-up,

operation maintenance and repair of the machine must have read and understood the Operation

Manual and in particular the “Safety” section, and comply with the instructions.

2.1.2 Improper use

Use of the machine for any purposes other than those intended or described in the present manual is

regarded as improper and therefore prohibited.

Trotec will not accept any liability for damage caused by improper use. The risks in case of improper

use are exclusively borne by the user.