Trotec SP3000 Инструкция по эксплуатации онлайн [17/87] 338817

SP3000

Safety

BA 8034_2.4_EN (12/2016) 17 / 87

www.troteclaser.com

2.3 Area of responsibility

2.3.1 Responsibilities of the operator

The operator has the following responsibilities:

- It is the responsibility of the operator to comply with the national official and statutory

regulations for the operation of a class 4 (US: class IV) laser system or laser system with a

build in laser source of class 4 (US: class IV).

- In addition to the safety notes and instructions stated in this manual, consider and observe the local

accident prevention regulations and general safety regulations that apply at the operation site of

the machine.

- A CO

fire extinguisher must always be at hand, as the laser beam can ignite flammable

materials.

- If the machine is used industrially, the operator is subject to the legal obligations concerning

industrial safety.

- All personnel involved in installation, set-up, operation, maintenance and repair of the machine

must have read and understood this manual and in particular the “Safety” section. The

personnel must be trained and informed about all the functions, potential dangers and safety

issues of the machine on a yearly basis.

- The user is recommended to prepare company internal instructions considering the

occupational qualifications of the personnel employed in each case, and the receipt of the

instruction/this manual or the participation in the introduction/training should in each case be

acknowledged in writing.

- Keep the manual in the immediate vicinity of the machine so that it is accessible at all times to

all persons working on or with the machine.

- Authority for the individual activities relating to the application of the machine (e.g. installation,

operation, maintenance and cleaning) must be clearly defined and observed, so that no

unclear competencies result under the aspect of safety. This applies in particular to work to be

performed on the electrical equipment that may only be performed by qualified specialists.

- Maintenance and repair work as specified in the manual must be carried out regularly.

- For all activities concerning installation, set-up, start-up, operation, modifications of conditions

and methods of operation, maintenance, inspection and repair, the switch-off procedures that

may be provided in the manual must be observed.

- Provide appropriate personal protection equipment (e.g. protective goggles according to

wavelength and laser power).

- The operator is responsible for the safety-related state of the machine.