Airwell Aqu@Fan AHC 9030 [15/44] Maintenance

UNIT INITIAL START-UP

After installing the fan coil unit, water and electrical connections being made, it is imperative to re-install the cabinet

on the AWC and AHC fan coil unit.

The cabinet will be fixed by the both screws, mentioned on section "Unit installation/Cabinet removal".

Before initial start up, be sure that the fan wheel is rotating free on it shaft.

Make sure that the filter is correctly positionned on its bracket.

FINAL TASKS

If needed, fix the cables and the pipes on the wall with clamping collars.

Operate the air conditioner in the presence of the user and explain all functions.

Show him how to remove, clean and place back the filters.

MAINTENANCE

REGULAR MAINTENANCE

These units have been designed for minimum maintenance through the use of permanently lubricated components.

However, there are operational maintenance requirements that require regular attention to ensure optimum

performance.

Maintenance must be performed by appropriately experienced personnel only.

WARNING :

Isolate unit from power supply before working on unit.

GENERAL INSPECTION

Carry out a visual inspection of the complete installation in service.

Check the general cleanness of the installation, and check if the condensate evacuations is not blocked, specialy

on the indoor coil, before the cooling season.

Check the condition of the condesate tray by pulling it out of the casing.

The user is responsible for ensuring that it is in a proper working condition and that technical installation

as well as the regular maintenance operations are performed by properly trained technicians and in

accordance with the instructions contained in this manual.

FOOT COVER REMOVAL

To remove the foot cover, press

and , and push as shown on photos.

To re-install it, do as above in the reverse way.