Maxwell MW-2402 [2/2] English

Maxwell MW-2402 [2/2] English
ENGLISH
CURLING IRONS
DESCRIPTION
1. Thermally insulated tip
2. Operating surface
3. Clamp
4. Lever
5. Power indicator
6. “O/L/H” operating modes switch
7. Support
8. Hanging loop
Attention! Do not use the device near
objects filled with water (sink, bath,
swimming pool etc.).
When using the device in a bath-
room, disconnect it immediately
after usage, pull the plug out of the
socket, as when water is near it is
dangerous even if the switch is off;
• For additional protection you can
install a residual current device with
nominal current of operation, not ex-
ceeding 30 mA, into the mains of the
bathroom; while installation contact
a specialist;
IMPORTANT SAFEGUARDS
When using electrical devices, espe-
cially when children are present, basic
safety precautions should always be
followed including the following:
BEFORE USING THE DEVICE
PLEASE READ ALL THE OPERATING
INSTRUCTIONS CAREFULLY.
To protect against risk of electric
shock:
Before using, make sure that your
home electricity supply corresponds
to the voltage specified on the hous-
ing of the device.
In order to avoid risk of fire do not
use adapters while connecting the
device to the outlet.
When using the device, we recom-
mend unwinding the power cord at
full length.
Always unplug the device after us-
age and before cleaning. To unplug
the device always take its plug, do
not pull the power cord.
Do not touch the power plug with
wet hands.
Do not place or store the device
where it can fall into a tub or sink,
filled with water.
Do not use the device in places
where aerosols or inflammable liq-
uids are used.
Place the device on a flat stable
heat-resistant surface.
Do not place the device on the soft
surface (a bed or a sofa), do not
cover the device.
Provide that the power cord is not
hanging over the edge of the table.
Do not use the device while taking a
bath.
• Never immerse the device into water
or other liquids.
If the device fell into water, unplug it
immediately, and only then you can
take the device out of water.
Never leave the operating device
unattended.
Do not use the device for styling
synthetic wigs.
Close supervision is necessary
when children or disabled persons
use the device. This device is not
intended for usage by children or
disabled persons unless they are
given all the necessary instructions
on safety measures and information
about danger, which can be caused
by improper usage of the device.
Use the device only for the intended
purposes.
Regularly check the power cord in-
tegrity.
Do not use the device if the plug or
the power cord is damaged, if the
device malfunctions or if the device
fell into water. Do not repair the de-
vice yourself; apply to the authorized
service center.
Keep the power cord away from
heated surfaces.
Do not twist the power cord and do
not wind it over the device.
Do not use the device when you are
drowsy.
Avoid contact of heated surfaces
with your face, neck and other parts
of your body.
Before touching the metal parts of
the device, let them cool down.
Be careful! The operating surface
remains hot for some time after un-
plugging the device.
Do not place the device on heat-sen-
sitive surfaces until it cools down.
Let the device cool down completely
before taking the device away for
keeping and never wind the power
cord over the device.
THE DEVICE IS INTENDED FOR
HOUSEHOLD USAGE ONLY.
Before you start
Unpack the device.
Before using the device for the first
time, make sure that your home
electricity supply corresponds to the
voltage specified on the housing of
the device.
Note:
- To get the best results of curling,
hair should be dry and clean.
- When using the device for the
first time, some smoke or foreign
odor can appear. It is normal.
Curling hair
Set the device on the support (7).
Note: Do not place the device on a
soft surface (a bed or a sofa etc),
do not cover the device.
Insert the plug into the socket, set
the switch (6) to the required oper-
ating mode:
“0” – the device is off;
“L” – low heating;
“H” – high heating;
• When setting the switch (6) to the “L
or “H” position, the indicator (5) will
light up.
Let the device heat up for 5 min-
utes.
Before curling comb the hair and di-
vide your hair into locks.
Press the lever (4). Place the end of
a lock under the clamp (3), drop the
lever (4) and wind the hair along the
whole operating surface (2). In 5-10
seconds (depending on the type of
hair) unwind the lock and release it
from the clamp (3).
Avoid contact the heated surfaces
with your face, neck and other parts
of your body.
Do not brush the hair immediately
after curling, let the locks cool down.
Divide the locks with your fingers for
the locks to look naturally.
After usage set the switch (6) to the
“O” position, the indicator (5) will
go out, and take the plug out of the
socket. Let the device cool down.
Note:
Always unplug the device if it is not
being used. Never leave the operat-
ing device unattended.
Clean and care
Before cleaning disconnect the de-
vice and let it cool down completely.
• Never immerse the device into water
or other liquids.
Wipe the outer surface of the device
with a soft damp cloth.
Do not use abrasives and solvents to
clean the device.
STORAGE
Always unplug the device if it is not
being used.
Before taking the device for storage,
let it cool down completely.
Never wind the cord around the de-
vice. It can cause damaging of the
device.
For convenient usage the device has
a hanging loop (8), you may use it to
store the device provided that water
does not get on the device.
Keep the device in a dry place, out
of reach of children.
Specifications
Power supply: 220 - 240 V ~ 50 Hz
Power consumption: 15 W
The manufacturer reserves the right
to change the device's characteristics
without prior notice.
Service life of appliance - 3 years
GUARANTEE
Details regarding guarantee conditions
can be obtained from the dealer from
whom the appliance was purchased.
The bill of sale or receipt must be pro-
duced when making any claim under
the terms of this guarantee.
This product conforms to
the EMC-Requirements as
laid down by the Council
Directive 89/336/EEC and to
the Low Voltage Regulation
(73/23 EEC)
RUS
Дата производства изделия указана в серийном номере на табличке с техническими
данными. Серийный номер представляет собой одиннадцатизначное число, первые
четыре цифры которого обозначают дату производства. Например, серийный номер
0606ххххххх означает, что изделие было произведено в июне (шестой месяц) 2006
года.
GB
A production date of the item is indicated in the serial number on the technical data plate. A
serial number is an eleven-unit number, with the first four figures indicating the production
date. For example, serial number 0606ххххххх means that the item was manufactured in June
(the sixth month) 2006.
4 5
Ñïàñèáî, ÷òî âûáðàëè ýëåêòðîùèïöû Maxwell
Скачать