Beko CS 58000 [39/72] Installation of gas lookers

Содержание

Похожие устройства

Installation of gas lookers o Before your appliance is connected to the gas supply check the ensure that the gas category and pressure specifications shown in the data plate corresponds with your gas supply If necessary call authorized service for adjusting to gas category This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated space Read the instructions before installing or using this appliances In the interest of safety this appliances must be installed and or serviced by a competent person as stated in the gas safety regulations current editions Please refer to the data plate for details about gas supply and pressures The appliance must not be installed in a room without a window or other controllable opening If is installed in a room without a door which opens directly to tohe outside a permanent opening is required The air circulation should be 2 m3 h per kW of burners Connection of the gas hose to the oven Connection of the gas hose to the oven Convenient position is selected by interchanging the hose nozzle and plug according to the location of the main gas inlet valve If you make a connection with a flexible metal hose locate a seal between the main gas pipe The inner diameter of the flexible hose which the butane hose nozzle is connected should be 6mm for the house type gas tubes The inner diameter of the flexible hose which the natural hose nozzle is connected should be 15mm The hose should tightly be fitted to the hose nozzle by squeezing with a clamp The plastic hose end is soaked in hot water for one minute to soften and inserted fully into the hose nozzle The clamp is fastened securely by a screw driver The other end of the hose is connected to the gas valve with the same operation The hose should be replaced before its last expiry date plug Convenient position is selected by interchanging the hose nozzle and plug according to the location of the main gas inlet valve The plastic hose end is soaked in hot water for one minute to soften and inserted fully into the hose nozzle The clamp is fastened securely by a screw driver The other end of the hose is connected to the gas valve with the same operation Gas leakage control During control be sure that the control knobs are closed and the gas inlet valve is open Apply soap bubbles to the connections for leakage control In case leakage exists buble will appear In such case check the gas connection immediately Do not control gas leaks by using fire Hose nozzle Caution Never use lighter or match flame for controlling the gas lackage Caution Make the oven connection to the gas inlet valve the hose length must be short and be sure that there is no Tube leakage The hose used should not be longer than 125 cm for safety 5 Hose nozzle and elbow types for Natural gas and Butane propane