UGUR UDD 500 SCEBN [22/110] Positioning
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

UGUR UDD 500 SCEBN [22/110] Positioning

UGUR UDD 500 SCB [22/110] Positioning
EN EN
C- INSTALLATION OF YOUR PRODUCT
Selectng the place of nstallaton
The operating environment of the product is very important for the smooth operation of your product. While select-
ing the operating environment,
Do not place your product exposed to outdoor environment (on the street, avenue, etc.).
Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a proper
cooling. (Picture 4)
Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.). (Picture 5)
Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 6)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your product’s glass. That means an
increase in the energy consumption.
Air intake and outlet must absolutely be uent and free for proper operation of the compressor section of your
product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and
back of your product.
WARNING!
In very humid environments, ensure that oor and wall of the place where the device is located, is not aected by water;
against discharge water overow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on the suitable
place for installation and make suggestion, but the consumer shall give the nal decision on where the installation will be
made. This above mentioned process shall also be stated on the relevant installation form by Authorized Uğur Service. In
case of any loss arising from the place of installation of the product according to the nal decision given by the consumer,
all responsibility related to such loss shall belong to the consumer.
Your product gives the best cooling performance according
to the climate condition under the conditions given below.
Therefore, be careful that the temperature of the environment
where your product will operate is at these levels.
Climate Class Temperature Range Humidity
Class 3 +16°C ile 25°C %60 Rh
Class 4 +16°C ile 30°C %55 Rh
Class 5 +16°C ile 40°C %45 Rh
Class 7 +10°C ile 35°C %70 Rh
Clmate Class of your product s ndcated on the techncal specfcaton label on the product.
PICTURE 5 PICTURE 6
PICTURE 2
PICTURE 4
C- INSTALLATION OF YOUR PRODUCT
PICTURE 7
15 cm
15 cm
Postonng
Possible placement positions:
1- In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150 mm (15 cm)
between the wall and your product. (Picture 7)
2- In a way that is place to a corner; when you place it to a corner, leave a gap of 150 mm (15 cm) behind.
You can lean the side, corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to obstruct ventila
-
tion of the compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is on its feet or
wheels.
The freer the compressor assembly ventilation is, the better the device will run.
42 43

Содержание

Похожие устройства

Скачать