Home
Главная
Aurora
Машинка Для Стрижки
AU 3083
Инструкция по эксплуатации Страница: 3

Aurora AU 3083 [3/11] Beginning of the haircut

ENG

Please read this manual carefully before using the product to avoid damage

during use. Before switching on the product, make sure that the technical

specifications of the product shown on the label correspond to the param-

eters of the electric network. Incorrect use can lead to damage of the prod-

uct, cause material damage or cause damage to the health of the user. Use

only for household purposes in accordance with this Manual. The product is

not intended for commercial use. Use the product only for its intended pur-

pose. Do not use the product near the kitchen sink, outdoors and in rooms

with high humidity. Always unplug the product from the electrical network

when it is not in use, as well as before assembly, disassembly and cleaning.

The product must not be unattended while it is connected to the electric

network. Make sure that the power cord does not touch the sharp edges of

furniture and hot surfaces. To avoid electric shock, do not attempt to disas-

semble or repair the product by yourself. When disconnecting the product

from the electric network, do not pull on the power cord, hold the plug. Do

not twist or wind the cord. The product is not designed to be operated by

an external timer or a separate remote control system. The product is not in-

tended for use by persons with reduced physical, sensory or mental abilities,

or if they have no experience or knowledge, if they are not controlled or in-

structed about the use of the device by the person responsible for their safety

Do not allow children to use the product as a toy. Do not use accessories that

are not included in the delivery suite. ATTENTION! Do not allow children to

play with plastic bags or wrapping film. THREAT OF SUFFOCATION! ATTEN-

TION! Do not use this product outdoors. ATTENTION! Be especially careful

if children under 8 years or people with disabilities are close to the product

in use. ATTENTION! Do not use this product near combustible materials, ex-

plosives, or self-igniting gases. Do not install this product near a gas or electric

stove, or other heat sources. Do not expose the product to direct sunlight.

ATTENTION! Do not allow children under 8 years to touch the kettle body,

the power cord and the plug of the power cord while the product is in op-

eration. If the product has been kept for a while at a temperature below 0ºC,

it must be left at room temperature for at least 2 hours before switching it

on. ATTENTION! Do not handle the power cord and the power cord plug

with wet hands. ATTENTION! Unplug the product from the electric network

every time before cleaning, and also if you do not use it. When connecting the

product to an electrical network do not use an adapter. ATTENTION! Regu-

larly grease the blades. It is not recommended to use hair oil, fats and oils of

vegetable origin, oils diluted with kerosene or other solvents for greasing. In

order to avoid overheating, do not use the product for more than 10 min-

utes and always take a break of at least 10 minutes. Do not use the machine

if you have inflammation of the skin. Do not shear animals. Do not let foreign

items and any liquids enter the openings on the product body. Do not place

the machine when it is working, as it may result in personal injury or material

damage. Do not use the machine with a damaged scallop as well as when

one of the teeth is damaged - it can result in injury. ATTENTION! The accumu-

lator life span is about 1 year and it depends on the intensity of the product

use. The battery needs to be recharged twice a year - after switching on the

product, wait until the motor stops completely. This must be done even if the

machine is not in use.

ACCUMULATOR REMOVING: The battery must be removed from the

product before it is disposed. When removing the battery from the prod-

uct, it must be completely discharged, the product must be turned off and

disconnected from the electric network. The battery must be delivered to a

specialized reception point.

SECURITY MEASURES

Unpack the product and remove packing material. Wipe the appliance

body and all the accessories carefully with a soft, slightly damp cloth.

CHARGING

Before initial start-up, it is necessary to discharge and charge the battery

completely. To charge the battery, turn off the product and connect it to the

electric network through the power adapter. The charging indicator will light

up. Full charging time is 8 hours. Continuous operation time is up to 60 min.

BLADES GREASING

To lubricate the blades, use the oil that is included in the delivery set. Grease

the blades with oil. Turn on the hairclipper, so that the oil is distributed be-

tween the blades evenly, check the uniformity of their stroke. Then turn o

the product and unplug it. Remove excess oil with a dry cloth.

PREPARATION FOR OPERATION

Turn off the machine and unplug it. Remove the remains of cut hair using the brush included in the delivery set. Wipe the product body and nozzles with a

damp cloth, wipe them dry after. Lubricate the blades with oil. Do not immerse the clipper in water or any other liquid. Do not use abrasive or chemical cleaners.

CLEANING AND CARE

Before storage, make sure that the product is disconnected from electric network. Complete all the requirements of the CLEANING AND

MAINTENANCE section. Keep the product in a dry, cool place and out of the reach of children

STORAGE

The best results are obtained when working with dry hair. For the rst time,

it’s best to leave longer hair after cutting. The length of the hair depends on

the used nozzle. Attach the nozzle on the blade. To get a at level haircut,

move the machine through the hair smoothly, do not make sharp move-

ments, cut o a small amount of hair at a time, and if necessary, return to

the treated area of hair to re-cut it. Remove the cut hair from the machine’s

blades. Brush your hair with a comb to identify uneven strands

TRIMMER ATTACHMENT AND DETACHMENT

Attach the necessary trimmer on a motor part of a product until it is fixed.

Press the release button and unplug the trimmer in order to detach trimmer.

CUTTING NOZZLES INSTALLATION

Align the guides of the nozzles with the grooves located on the trim-

mer, gently push the nozzle until it clicks.

HAIRCUT WITH TH USE OF UNIVERSAL NOZZLE

The universal nozzle has 5 positions for dierent lengths of cut hair.Install

the universal nozzle by attaching the guided nozzles into the grooves of

the appliance body. Attach the hair clip to the trimmer. To get the de-

sired result you can choose the desired length of cut hair - 12 mm, 14

mm, 16 mm and 20 mm.

TRIMMER FOR NOSE AND EARS

Attach the trimmer onto the motor part of the product until it locks into

place. Smoothly insert the trimmer into the nostril or ear. Carefully move

the trimmer in the nose or ear back and forth while turning it. Do not insert

the trimmer into the nostril or ear deeper than 5 mm. When removing hair

from the eyebrows, carefully draw the cutting block over unwanted hair.

BODY TRIMMER

Attach the trimmer onto the motor part of the product until it locks

into place. Attach the body nozzle to the trimmer. To obtain the de-

sired result, you can choose the length of cut hair - 3 mm, 6 mm and 9

mm. Slowly move the trimmer with the nozzle in the direction of hair

growth. If hair is accumulated in the guide nozzle during the haircut,

turn the appliance o, detach the nozzle and brush it.

SHAVING TRIMMER

Attach the trimmer onto the motor part of the product until it locks

into place. During shaving, hold the trimmer at a right angle (90 °) to

the skin. ATTENTION! Excessive pressure of the trimmer on the skin

during operation does not improve the quality of shaving, and may

lead to damage to the shaving net. Every time before operating the

trimmer, check the net for damage or wear. If a net is found to be dam-

aged, do not use a trimmer as this may result in injury.

BEARD TRIMMER

Attach the trimmer on the motor part of the product until it locks into

place. Attach the adjustable nozzle onto the trimmer and select the

desired length of cut hair.

BEGINNING OF THE HAIRCUT

Aurora AU 3083 [3/11] Beginning of the haircut

Содержание

Похожие устройства