Hottek HT-960-402 [12/20] Attention

ENG

• Before using the kettle, pour water into the kettle, boil it, and then drain it.

Do this several times. Every time ll the kettle with fresh, cold water to the

maximum point.

• To ll the kettle with water turn on the tap and let the water run for 1-2

minutes before ll it into the kettle.

• Always pull out the plug from the socket, if you ll up or add water into the

kettle without taking it o the stand.

Using the appliance

• Place the stand on a dry, solid, and horizontal surface.

• Fill the kettle with the required amount of water. Check the water level on the

scale (6) on the kettle body. Make sure that the water level is between the

minimum and maximum points.

• The amount of water less than 0.5 liter (below the minimum level) can lead

to water boil-o, heating and breaking the empty kettle.

• The water exceeding the maximum point (1.7 L) will be splash out when

boiling.

• Make sure that the kettle cover (3) is closed correctly and rmly, otherwise

the kettle does not switch o automatically.

• Put the kettle on the stand. The base of the kettle has to t exactly into the stand.

• Pull the plug into the socket.

• Turn the “O/I” switch (5) to position “I”, after that the illumination will light up

and heating will begin.

• Do not touch any parts of the kettle, except for the handle.

• When the water boils, the illumination will put out and the kettle will shut o

automatically. The switch “O/I” (5) will return automatically to position “O”.

The kettle can be turned o manually by moving the switch to “O/I” (5) to

position “O”.

• Take the kettle o the stand and pour the water into the cups carefully. The

kettle must be switched o.

Attention!

Your kettle is equipped with an overheating protection system. If in teapot

there is no or little water, it will turn o automatically when overheated. If this

happened, it is necessary wait at least half an hour for the kettle to cool down,

after which you can pour water.

Dry boil protection

Should you accidentally let the kettle operate without water, the dry boil

protection will automatically switch o the power. If this occurs, allow the kettle

to cool before lling with cold water to reboil.