Faber INCA LUX GLASS EG8 X/WH A52 [9/140] Installation

Faber INCA LUX GLASS EG8 X/WH A52 [9/140] Installation
EN
9
9
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
Disconnect the wires to the Commands at the connectors.
Disconnect the wires to the Light at the
connectors.
The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
Create an opening in the bottom of the wall unit,
as shown.
Insert the hood until the side supports snap into
place.
Fasten using the 10 screws 12a provided.
Lock in position by tightening the screws Vf from
underneath the hood.
Open the suction panel by turning the specific knob.
Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
Remove grease filters.
Screw the Frame into place
using the 6 screws 12f, re-
connect the wires to the
Commands and Light,
replace the metal grease
filter and the Panel.
500 - 680
260
13
495 - 675

Содержание

Похожие устройства

INSTALLATION Fitting the Hood canopy BEFORE FITTING THE HOOD TO THE WALL UNIT PROCEED AS FOLLOWS The Hood can be installed directly on the underside of the wall unit Minimum 650 mm from the Cooker Hob Create an opening in the bottom of the wall unit as shown Insert the hood until the side supports snap into place Fasten using the 10 screws 12a provided Lock in position by tightening the screws Vf from underneath the hood Open the suction panel by turning the specific knob Disconnect the panel from the hood canopy by sliding the fixing pin lever Remove grease filters Screw the Frame into place using the 6 screws 12f re connect the wires to the Commands and Light replace the metal grease filter and the Panel EN 9

Скачать