Gorenje WHT941ST 498349 [10/139] Cleaning

After performing the maintenance, with the hood off and the button active, press the button for more than 3 seconds to

perform the reset of the filter saturation indicator; repeat the operation if necessary (for ex., when both filters are saturated).

Activation of the charcoal filter saturation indicator

The saturation indicator of the charcoal filter is normally disabled. To activate it, proceed in the following manner:

With the display on (ON) and the suction off (OFF), press simultaneously the buttons T8 and T9 for more than 3 seconds;

the button T9 lights on with steady light for approx. 5 seconds, to indicate the activation.

To disable it, repeat the operation; the button T9 will flash for approx. 5 seconds to indicate the disabling.

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform "Hood Calibration" and "Selection of the hob".

Hood Calibration

With the display on (ON) and the suction off (OFF), press button T4 for 5 seconds.

The suction speed (power) 2 starts functioning and button T4 flashes to indicate that hood calibration is initiated and it will last for

approx. 15 minutes.

Note: to interrupt the calibration, press T4 for 5 seconds; the calibration will be invalidated and should therefore be repeated.

Selection of the cooktop

With the display on (ON) and the suction off (OFF), press button T3 for 5 seconds.

Model with 2 levels of intensive power T5 (POWER BOOST) e T6 (POWER BOOST x 2)

Buttons T3, T5 and T6 light up.

Press the button T5 for the gas cooktop – the button flashes to indicate its selection.

Press the button T6 for the electric cooktop- the button flashes to indicate its selection.

Model with one level of intensive power T5 (POWER BOOST)

Buttons T3, T7 and T8 light up.

Press the button T7 for the gas cooktop – the button flashes to indicate its selection.

Press the button T8 for the electric cooktop- the button flashes to indicate its selection.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the

connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat

filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO

NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause

fire risks.

Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance

or failure to observe the above safety recommendations.

Grease filter

Traps cooking grease particles.

The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must

be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does

not affect its filtering capacity.