Home
Главная
Hotpoint-Ariston
Электрическая панель
DK B (IX) Серебристый
Инструкция по эксплуатации Страница: 4

Hotpoint-Ariston DK B (IX) Серебристый Инструкция по эксплуатации онлайн [4/28] 379462

3. Loosen the cable clamp screw and the terminal

board screws in accordance with the type of

connection required and position the connection

supports as shown in the following table and

diagrams.

4. Position the wires in accordance with the

information given in the following table and diagrams

and connect the appliance by tightening all the

screws for the springs as much as possible.

Voltage and

mains frequency

Electrical connections Terminal board

400V 3-N ~

50/60 Hz

Three-phase 400

5. Secure the power supply cable by fastening the

cable clamp screw, then put the cover back on.

Three-phase 400

Connecting the electricity supply cable to the

mains

If the appliance is being connected directly to the

electricity mains an omnipolar switch must be

installed with a minimum opening of 3 mm between

contacts.

! The installer must ensure that the correct electrical

connection has been made and that it is fully

compliant with safety regulations.

Before connecting the appliance to the power

supply, make sure that:

• The appliance is earthed and the plug is

compliant with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data

plate located on the appliance itself.

• The voltage falls within the range of values

indicated on the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only.

! The manufacturer declines any liability should

these safety measures not be observed.

! Do not remove or replace the power supply cable

for any reason. Its removal or replacement will void

the warranty and the CE marking. INDESIT does not

assume liability for accidents or damage arising

from replacement/removal of the original power

supply cable. Replacement can only be accepted

when carried out by personnel authorised by

INDESIT and using an original spare part.

U-bolt

connection support

Neutral

Earth

Phase Phase Phase

Hotpoint-Ariston DK B (IX) Серебристый Инструкция по эксплуатации онлайн [4/28] 379462

Содержание

Похожие устройства