D-Link DGS-3620-52P [1267/1371] Restrictions

D-Link DGS-3620-52P [1267/1371] Restrictions
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1262
process
<int 1-254> - Enter the priority value used here. This value must be between 1 and 254.
advertisement_interval - (Optional) Specifies the time interval used between sending
advertisement messages.
<int 1-255> - Enter the advertisement interval value here. This value must be between 1 and
255 seconds.
preempt - (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within the
same VRRP group. Default is settings is true.
true - Specifies that if the backup router’s priority is set higher than the masters priority, it will
become the master instead of the current one.
false - Specifies that if the backup router’s priority is higher than the masters priority, it will not
become the master until the master failed.
critical_ip - (Optional) Specifies an IP address that will provide the most direct route to the
Internet or other critical network connections from this virtual router. This IP address must be a
real IP address of a real device on the network. If the connection from the virtual router to this
IP address fails, the virtual router will automatically be disabled. A new Master will be elected
from the backup routers participating in the VRRP group. Different critical IP addresses may
be assigned to different routers participating in the VRRP group and can therefore define
multiple routes to the Internet or other critical network connections.
<ipaddr> - Enter the critical interface's IP address used here.
critical_ip_state - (Optional) Specifies the state of checking the status (active or inactive) of a
critical IP address.
enable - Specifies that the critical IP state checking will be enabled.
disable - Specifies that the critical IP state checking will be disabled.
bfd_peer - (Optional) Specifies the IP address of the Bidirectional Forwarding Detecton (BFD)
peer. This IP address should be a real IP address of a VRRP router in the same VRRP group.
A BFD session will be created between the local VRRP virtual router and the peer. If the local
VRRP virtual router is in the Backup state and the BFD peer address is the Master router, it
will try to switch to Master fast when the BFD session goes down. Using the IP address
0.0.0.0 will disable BFD on this VRRP virtual router.
<ipaddr> - Enter the IP address here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a VRRP entry:
DGS-3620-28PC:admin# create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state
enable
Command: create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state enable
Success.
DGS-3620-28PC:admin#
120-4 config vrrp vrid
Description
This command is used to configure the virtual router settings by VRID.

Содержание

Похожие устройства

Скачать