D-Link DCS-960L [5/16] Mounting the camera

DCS-960l

ENGLISH

mOUNTING THE CAmErA

Please refer to the steps below to assist you with mounting the camera. It is recommended that you

congure the camera before mounting.

Step 2:

Place the base plate where you want to position the camera and

use a pencil to mark the holes. Make sure the holes are lined up

horizontally.

Step 3:

Depending on the material of the wall or ceiling, use proper tools to

drill two holes 25mm deep with a 6mm drill bit where you marked. If

the wall is made out of concrete, drill the holes rst, then insert the

plastic anchors to support the screws.

Step 4:

Place the base plate over the holes that are in the wall. Make sure to

align the base plate holes with the holes in the wall. Use the supplied

screws to attach the base plate to the surface of the wall. Do not

overtighten screwheads as this may crack the mount.

Step 1:

Turn the base plate on the bottom of the camera counterclockwise

with a coin to remove it.

Step 5:

Place the camera over the base plate and turn the camera clockwise

to lock it in place.

Step 6:

Adjust the angle of the camera as desired. When adjusting the

camera, use one hand to hold down the camera base to prevent it

from turning.