Hyundai H-LCD3700 Инструкция по эксплуатации онлайн [11/39] 42759

During searching, press MENU button to quit the automatic search and go back to the previous menu.

Automatic searching starts from Channel 1, all the searched channels will be stored automatically. Dur-

ing searching, the modes of color and sound are automatically stored, thus to make sure the searched

channel later can be played correctly.

After automatic search has been compete, or the capacity of storing 236 channels has been used up, or

the MENU button is pressed during searching, the system will quit from automatic searching mode and

go back to the previous channel setting menu and switch to Channel 1 automatically.

· Manual search. In TV mode, press V+/V- buttons to search the signal upwards or downward, the system

will stop after one channel is searched, the current channel can be stored through pressing OK button. If

you are still going to search, you can press V+/V- buttons. During searching, the system will quit the

manual searching and will be back to the settings before the searching, also, you can watch the program

by directly inputting the corresponding frequency number through the number buttons, but you have to

be sure the number input is within the range of the system, otherwise, the input will be invalid.

· AFT. In TV mode, select Fine tuning, press V+/V- buttons to finely tune the frequency and to turn

on/off the automatic frequency tracking, the searched program will be stored automatically after tuning.

· Label. Select this item, press OK button or V+/V- buttons to enter submenu to edit the name of each

channel, select the character by P+/P- buttons, press V+/V- buttons to edit the next character after the

previous character edition is complete, operate by this way until the whole edition is complete. Press

OK button or MENU button to save the settings and go back to the previous channel setting menu.

· Program Edit. In TV mode, select the channel sorting item,

press OK button or V+/V- buttons to enter into editing

mode as described in the following picture.

Press P+/P- buttons to highlight the channel you wish to edit,

the operation sequence is to press V+ button to confirm, and

then press P+/P- buttons to select the position you wish to put

the channel in, then press V- button to finish the channel se-

quencing operation. If this channel is your favorite channel, you

can add the mark “

” to the channel as your favorite channel

by press GREEN color button.

Note: In AV, SVIDEO, COMPONENT, PC and HDMI mode,

there is no channel setting information.

Information of “SETUP” displayed in AV and SVIDEO mode.

· Color System. You can select AUTO to allow the system to identify the color mode automatically or

choose the color mode by yourself if the video color is not right.

Information of “SETUP” displayed in VGA mode

· Auto Adjust. Automatic position and effect adjustment of the picture. If the picture position is not so

good, you can select this function.

· Phase. Phase adjustment of the picture: in VGA mode, this function can be worked when there is any

abnormality of pictures.

· H Position. Moving the picture horizontally through V-/V+ buttons.

· V Position. Moving the picture vertically through V-/V+ buttons.