Kress Mission KR110 [21/25] Troubleshooting
Макгруп McGrp.ru

Kress Mission KR110 [21/25] Troubleshooting

Превью страниц Страница 21 / 25
Kress Mission KR110 [21/25] Troubleshooting
21
EN
13. Troubleshooting
If your Mission™ does not work correctly, follow the trouble shooting guide below. If the fault persists,
contact your dealer.
Symptom Cause Solution
The LED light on the charging
base does not turn on.
There is no power.
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Green light flashing on the
charging base.
The boundary wire isn’t
connected.
Check that the boundary wire has been
connected correctly to the charging
base.
Check there are no breaks in the
boundary wire, especially in the wire
ends.
Mission™ turns on, but the
blade disc does not move.
Mission
TM
is searching for the
charging base (except that you
press the HOME button to make
it go to the charging base, or
the “Border cut” function is
operating).
This is normal, Mission™ needs to
recharge, the blade disc does not rotate
while it is searching for the charging
base automatically.
Mission™ vibrates.
Blades may be damaged.
Check condition of the blade
disc.
Check the blades, and replace them if
damaged.
Remove debris and foreign objects from
the blades and blade disc.
Grass is being cut unevenly
Mission™ does not work
enough hours per day.
Add more hours to the mowing time.
Mowing area is too big.
Try decreasing the size of the mowing
area or adding more hours to the
mowing time.
Blades are dull.
Change all the blades and screws in
order to balance the bade disc.
The cutting height is set too low
for the length of the grass.
Raise the cutting height and then
gradually lower.
Grass or other object has
wrapped around the blade disc.
Check the blade disc and remove the
grass or other object.
There is a build-up of grass in
the blade disc or motor frame
box.
Make sure the blade disc rotates easily.
If need be, you may take off the blade
disc and then remove the debris. See
How to Clean.
Your Mission
TM
is inside its
territory and the boundary wire
is connected. But the display
says “Outside working area!
Press “START” to reset”.
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends.

Содержание

42

Похожие устройства

Google Play RuStore