Carrier 38QUS018DS-2 Инструкция по монтажу(ENG) онлайн [18/41] 389783

 Page 18 

Drainpipe

Installation

Using a 65-mm (2.5”) core drill, drill a hole in

the wall. Make sure that the hole is drilled at a

slight downward angle, so that the outdoor

end of the hole is lower than the indoor end

by about 12mm (0.5”). This will ensure proper

water drainage (See Fig. 5.5). Place the

protective wall cu in the hole. This protects

the edges of the hole and will help seal it

when you nish the installation process.

Wall

IndoorOutdoor

≈ 12mm / 0.5 inch

Fig. 5.5

NOTE: When drilling the wall hole, make sure

to avoid wires, plumbing, and other sensitive

components.

4. Pass the drain hose through the wall hole.

Make sure the water drains to a safe location

where it will not cause water damage or a

slipping hazard.

NOTE: The drainpipe outlet should be at

least 5cm (1.9”) above the ground. If it

touches the ground, the unit may become

blocked and malfunction. If you discharge

the water directly into a sewer, make sure

that the drain has a U or S pipe to catch odors

that might otherwise come back into the

house.

NOTE: When connecting multiple drainpipes,

install the pipes as shown in Fig 5.4.

0-53cm

(20.8”)

≥10cm

(4”)

Fig. 5.4