Gigaset A420 Trio Black [19/24] Questions and answers

Gigaset A420 AM [19/24] Questions and answers
19
Gigaset A420-A420A / Großbritannien / A31008-M2402-L101-1-7619 / Bali.fm / 19.04.2012
Template Bali, Version 1, 16.02.2012
Questions and answers
If you have any queries about the use of your telephone, visit our website at www.gigaset.com/service
for 24-hour support. The table below contains a list of c
ommon problems and possible solutions.
Contact with liquid
If the handset has come into contact with liquid:
1 Switch the handset off and remove the battery immediately.
2 A
llow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,
warm plac
e for at least 72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is completely dry.
Wh
en it has fully dried out, you will usually be able to use it again.
Problem Cause Solution
Nothing appears on
the displa
y.
The handset is not switched on.
The batteries are flat.
Press the end call key a for approx. 5 seconds or place
the handset in the base station.
Charge or replace the batteries.
No wireless connec-
tion to the base sta-
tion, Ba
se flas
hes in
the display.
The handset is outside the range of
the base station.
Th
e base station is not turned on.
Move the handset closer to the base station.
Check the mains connector on the base station
¢ page 3.
The display shows
Register
HS or Put
into base.
Handset has not been registered
with the base station or has been
de-registered.
Register the handset ¢ page 13.
Handset does not
ring.
Th
e ring tone is deactivated.
The phone only rings if the phone
number
has been transferred.
The phone does not ring in a spe-
cific time period.
Activate the ring tone
¢ page 16.
Activate the ring tone for anonymous calls
¢ page 15.
Deactivate the "Time Control" or change the time period
¢ page 15.
You cannot hear a
ringer/di
alling tone
from the fixed line
network.
The phone cord supplied has not
bee
n used or has been replaced by
a new cord with the wrong jack
connections.
Please always use the phone cord supplied or ensure
th
at the pin connections are correct when purchasing
from a re
tailer: 3-4 assignment of telephone leads/
EURO CTR37.
Error tone sounds
aft
er system PIN
prompt.
PIN forgotten.
The system PIN you have entered is
in
correct.
Reset the system PIN to the default 0000 ¢ page 16.
All handsets are de-registered. All settings are reset.
All lists ar
e deleted.
!

Содержание

Похожие устройства