Helvi Combi PC302K Инструкция по эксплуатации онлайн [9/64] 394383

Decide for the desired

application

Cutting with inside air

compressor

Cutting with external

compressed air source

Max current = 25 Amp Max current = 28 Amp

Nozzle with hole ø 0,65mm

Shield cup marked

“compressor”

Check set current

Current < 20 Amp

Current > 20 Amp

Nozzle with hole ø 0,65mm

Shield cup marked “06”

Nozzle with hole ø 0,8mm

Shield cup marked “06”

Select the compressed air source through the selector

switch (9) on the back of the unit

Proceed with cutting operation

COMPRESSED AIR SOURCE

NOTE: the instructions regarding the use with external air source are valid only for the model

with double function (internal compressor / external compressed air source).

The plasma cutting process requires a compressed air source: this unit can work either with the inside air

compressor or with an external compressed air source.

The use of an external compressed air source allows a wider cutting current range and permits to cut thicker

workpieces.

Select the proper mode for your application. For proper selection and consumable parts installation follow

the here below chart: