Helvi Combi PC202K Инструкция по эксплуатации онлайн [3/64] 394384

CAUTION!

BEFORE INSTALLING, OPERATING OR CARRYING OUT MAINTENANCE ON THE

PLASMA CUTTER, READ THE CONTENTS OF THIS MANUAL CAREFULLY, PAYING PAR-

TICULAR ATTENTION TO THE SAFETY RULES.

In the event of these instructions not being clear, please contact your supplier.

CONGRATULATIONS ON YOUR NEW PURCHASE!

YOU ARE NOW IN THE POSSESSION OF ONE OF THE SAFEST AND MOST TECHNOLOGI-

CALLY ADVANCED PLASMA CUTTERS ON THE MARKET.

FOLLOW OUR SUGGESTIONS AND YOU WILL BE GUARANTEED SAFE AND PROBLEM-

FREE OPERATION.

Your plasma cutting unit is tted with sophisticated safeguards which block

functioning and therefore the cutting operations until all the safety conditions

are present. The plasma cutting technique requires dangerously high voltage

for pilot arc starting and during cutting, therefore the following safety rules

must be observed with great care.

ELECTRICITY

1-Make sure that the unit is earthed and that the supply line has an adequate

earth connection.

2-Make sure that the work bench has a satisfactory earth connection.

3-Avoid contact between the metal bars being cut and bare skin or damp

clothes.

4-Do not lean on the piece being cut or hold it in your hands.

5-Do not carry out cutting operations in damp environments or on wet surfaces.

6-Do not use the unit if the torch or cables appear damaged.

7-Always turn the unit off before replacing the electrode, the nozzle or the spreader tip of the torch.

8-Always switch the unit off and remove the power cable from the mains socket before carrying out

any maintenance inside the unit.

EYE AND BODY PROTECTION

One of the hazards during the welding/cutting process is the emission of electromagnetic waves due

to the electric arc. The length of these waves ranges from infrared to ultraviolet. If these rays hit the

eyes, they can cause various complaints such as conjunctivitis, burns to the retina, deterioration of

sight, etc. Moreover a high concentration of ultraviolet rays can burn the skin. It is, therefore, extremely

important that the operator uses adequate safety equipment and clothing, such as:

SAFETY RULES AND GENERAL WARNINGS

INTRODUCTION

CAUTION!

Repairs, maintenance and operation of the unit should be carried out by trained personnel

who are aware of the risks caused by the high voltage needed to operate the plasma cutting

unit. The operator should work in compliance with current standards and abide by all safety

regulations.

CAUTION!

If during the cutting operation a slight electric shock is felt, stop work immediately and do not

use the unit until the fault has been discovered and resolved.