Ada TemPro 2200 А00129 — инструкция по использованию термометра и функции логирования [44/60]

Превью страниц Страница 44 / 60

MEASUREMENT FOUNDATION

TemPro 1200/1600/2200

Recalling data

To recall stored data after the unit shuts off, press the “MODE” button until LOG appears in the lower left corner. A LOG lo-

cation number will be shown below LOG, and the stored temperature for that location will be displayed. To move to another

LOG location, press the “Down” (2) and “Up” (3) keys.

Log clear function

The “Log clear” function allows you to clear quickly all logged data points. This function can be only used when the unit is in

LOG mode. It can be used when the user has any number of LOG stored locations.

You should only use the LOG clear function if you want to clear all the Log location data stored in unit’s memory.

While in LOG mode, press the trigger (5) and then press the “Down” (2) arrow button until you reach “0” LOG location.

Note: This can be done when the trigger is pulled. LOG location “0” cannot be accessed by pressing “Up” (3) arrow button.

When “0” LOG location is shown on the dispaly, press the Laser/Backlight (1) button. You will hear sound and “0” will auto-

matically change to “1”. All data locations have been cleared.

7. Operation

Preparation before operation

Read the operating manual before use the instrument.

Take the instrument out of case.

Open battery cover and put 9V battery.

Thermometer On/Off

Pull and hold the trigger (5) to turn the meter on and begin testing. The display will light if the battery is good. Replace the

battery if the display does not light. The meter will automatically power down after approximately 7 secondsafter the trigger

is released.