Dometic TEC 30EV [23/284] Securing the silencer

TEC30D EV Installation

Hanging installation (A)

Proceed as follows:

➤ Remove the brackets (fig. 3 1, page 4).

➤ Mount the brackets upside down (fig. 3 2, page 4).

You can determine the exact position of the drillings using the drilling template

which is included in the packaging (fig. 3 B, page 4).

➤ Fasten the mounting brackets (fig. 4 1, page 4; accessory, not included in the

delivery) to the desired place.

➤ Fix the generator together with the dampers (fig. 4 2, page 4).

Upright installation (B)

Proceed as follows:

➤ Drill the mounting holes at the desired area using the drilling template which is

included in the packaging (fig. 5, page 5).

➤ Drill the drain hole using the drilling template which is included in the packaging

(fig. 5, page 5).

➤ Fit a seal (fig. 6 1, page 5) made of fire-retardant rubber with a thickness of at

least 5 mm into the drain hole.

➤ Place the generator in the desired area.

➤ Fix the generator together with the dampers (fig. 7 1, page 5).

9.3 Securing the silencer

Observe the following instructions when installing the exhaust pipe:

• Do not create any sharp bends which will inhibit the flow of exhaust fumes.

• Comply with the minimum bending diameter of 160 mm to avoid cracks in the

exhaust pipe.

• Use the exhaust pipe extension to extent the the exhaust pipe (see chapter

“Accessories” on page 21).

Secure the extension to the vehicle floor.

➤ Secure the silencer (fig. 8 7, page 6) as in one of the alternatives shown in

fig. 9, page 6 to fig. c, page 8.

TEC30D-EV--I-16s.book Seite 23 Freitag, 10. März 2017 3:48 15