Dometic SINEPOWER DSP 2012 [17/310] Switching to energy saving mode

SinePower Using the inverter

➤ Check that the inverter is sufficiently ventilated and that the ventilation grilles are

unimpeded.

➤ Wait 5 – 10 minutes and switch the inverter on again without any electric

consumers.

9.3 Switching to energy-saving mode

Activating energy saving mode

➤ If necessary, switch the inverter off.

➤ Press the on/off button (fig. 3 1) of the remote control until the status LED

(fig. 3 2) of the remote control has flashed six times.

✓ Then the status LED (fig. 3 2) of the remote control flashes every 5 seconds.

✓ Energy saving mode is activated.

Deactivating energy saving mode

➤ Switch the inverter off.

➤ Press the on/off button (fig. 3 1) of the remote control until the status LED

(fig. 3 2) of the remote control goes on constantly.

Before the status LED goes on constantly, it indicates that energy saving mode

will be switched off by an interval of flashing four times followed by flashing six

times.

✓ Normal mode is activated.

NOTE

• The inverter automatically switches to normal operation when a load

over 45 W is connected.

• If an external switch is connected, you cannot change the energy

saving mode.

DSP600-2000--IO-16s.book Seite 15 Montag, 7. Mai 2018 1:39 13