Weissgauff GAMMA 50 PB BL [25/36] The changes in flue channel sections are not advised from higher section to lower section for example the change from ø150 mm to ø120 mm

 



The changes in flue channel sections are not advised (from

higher section to lower section, for example the change from Ø150

mm to Ø120 mm).

As the absorber: the vapours are cleaned from fat and odours, before they are

returned back to the premise through the grills in the top part of the chimney

body. To make the hood work in the absorber mode, install the coal filter

(Fig.10). The coal filter is not included in the standard equipment, and should

be acquired separately.

Hood installation

NOTE:

The use of screws and fastening elements not specified in the

Operation Manual may cause the electrical shock.

The minimum distance of hood hanging between the surface of kitchenware

placement over the cooking range (gas, electric range), and lowest part of the

hood (Fig.3) shall amount at least

45 cm for electric cooking ranges

and at least 65 cm for gas cooking

ranges. Should the cooking range

operation manual provide the

higher distance for hood

installation, such higher distance

requirement shall be maintained.

The installation of the hood and

chimney body is shown at the

figures (Fig.4 - Fig.9). The hood

is equipped with the fixing pins

matching to the most part of walls and ceilings. In course of the assembly,

observe the common rules for air exhaust from the premises.

Before starting the installation:

 Check if the purchased device dimensions match to the planned

installation place.

Gas cooking ranges L 65cm

Electrical cooking ranges L 45cm

Fig. 3 Recommended distances from the cooking range.