Viconte vc-1469 [3/16] Blade alignment

v Do not immerse the appliance in water or other liquids.

v Do not use an appliance that has fallen into water. Unplug it immediately.

v Use this appliance only for its intended use as described in this manual.

v Do not use attachments not recommended by the manufacturer.

v This appliance should never be left unattended when plugged in.

v Close supervision is necessary when this appliance is used on, or near children or invalids.

v Never operate this appliance if it has a damaged cord or plug, if it is not working properly.

v Keep the cord away from heated surfaces.

v Do not pull, twist, or wrap the power cord around appliance.

v Never drop or insert any object into any opening of this appliance.

v Before use, make certain of blades are aligned properly.

v Do not place appliance on any surface while it is operating.

v Do not use this appliance neither with a

damaged or broken comb nor with teeth missing from the blades as injury

may occur.

NOTE: KEEP BLADES OILED.

BLADE ALIGNMENT

v Your clippers were carefully examined to ensure that the blades were oiled and aligned be-

fore leaving our factory.

v Blades must be realigned if they have been removed for cleaning or replacement.

v To realign the blades, simply match the upper and

bottom blades teeth up, point for point.

v End of top blade teeth should be approximately 1.2 mm back from bottom blade. Compare your clipper

blades with the sketch.

v If blade a

lignment is incorrect, add a few drops of oil to the blades, switch on clipper for a few moments,

switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned.

OIL

v To maintain your clipper in peak condition, the blades should be oiled every few haircuts.

v Do not use hair oil, grease, oil mixed with kerosene or any solvent. As the solvent will evaporate and leave

the thick oil which may slow down the blades motion.