Benq PU9220+ [15/81] Replacing the remote control battery

Introduction 15

Replacing the remote control battery

1. To open the battery cover, turn the remote control

over to view its back, push on the finger grip on the

cover and slide it up in the direction of the arrow as

illustrated. The cover will slide off.

2. Remove any existing batteries (if necessary) and install

two AA batteries observing the battery polarities as

indicated in the base of the battery compartment.

Positive (+) goes to positive and negative (-) goes to

negative.

3. Refit the cover by aligning it with the base and sliding

it back down into position. Stop when it clicks into

place.

• Avoid excessive heat and humidity.

• There may be battery damage if the battery is incorrectly

replaced.

• Replace only with the same or equivalent type

recommended by the battery manufacturer.

• Dispose of the used battery according to the battery manufacturer’s instructions.

• Never throw a battery into a fire. There may be danger of an explosion.

• If the battery is dead or if you will not be using the remote control for a long time, remove

the battery to prevent damage to the remote control from possible battery leakage.