Scarlett SC-4003 [2/7] Ac operation

DESCRIPTION

1. On/Off/Auto/Alarm switch

2. Dimmer switch

3. Sleep button

4. Alarm Set / Off button

5. Hour button

6. Minute button

7. Time set button

8. Snooze button

9. Volume control regulator

10. Band switch

11. Tuning control knob

12. Dial

IMPORTANT SAFEGUARDS

· CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Prefer

servicing to qualified service personnel.

· DANGEROUS VOLTAGE: Uninsulated dangerous voltage, that may be of sufficient

magnitude to constitute a risk of electrical shock to persons, is present within this product

enclosure.

· ATTENTION: The owners manual contains important operating and maintenance

instructions for your safety, it is necessary to refer the manual.

POWER SUPPLY

BATTERY OPERATION

· Connect a 9 volt (006P) battery (not included) to the terminals inside the battery

compartment. Your set will not work normally from the mains supply, but there is now the

advantage that, in case there is a mains current failure, your clock will continue to work. The

clock display will not light up, as the clock time will be held in the clock memory by the

battery back-up system. This enables you to move the set from place to place without re-

setting the clock every time. The battery back-up system is only meant to be used from short

temporary power failures. For longer durations the battery may become exhausted or there

may be some deviation in accuracy.

· When the battery is exhausted, it should be removed from the set to prevent leakage. If you

do not wish to take advantage of the battery back-up system, your set will work normally

without a battery. However, if disconnected from the mains, the clock figures will flash when

the mains are re-connected and you must re-set the clock as described in the AC Operation

paragraph.

AC OPERATION

· The appliance is for household use only.

· Before the first connecting of the appliance check that voltage indicated on the rating label

corresponds the mains voltage in your home.

· Insert the plug into the power supply.

· The set is now working as an electronic clock and it will flash the clock figures to show you it

is not set correctly.