Laserliner DigiLevel Plus 120 081.254A [7/52] Digilevel plus

DigiLevel Plus

Switching on and measuring

The DigiLevel Plus can measure angles continuously

to 360°.

– Switch the DigiLevel Plus on using the on/off switch (4).

– The slope angle is shown in the display (8). If slopes

are measured overhead, the direction of display

adjusts automatically.

– The current slope direction is also shown by

the symbol (7).

Selection of unit of measurement

Button (5) allows the desired unit of measurement to be

selected (° degrees, %, mm/m).

Inserting batteries

Open the battery com-

partment and insert

batteries according

to the symbols. Be

sure to pay attention

to polarity.

Calibration

1. Place the measuring face (17) on an even surface with

position mark (see Fig. below). Switch on device (4) and

keep the CAL button (3) pressed until CAL 1 appears

on the display.

2. Press the CAL button (3) again. CAL 1 ashes. The

display then switches to CAL 2 and a signal sounds.

3. Now turn the spirit level vertically by 180° and

place exactly on the marked surface (reverse

measurement).

4. Press the CAL button (3) again until CAL 2 ashes.

The subsequent acoustic signal concludes the process.

The unit is properly calibrated when it displays

the same measurement value, i.e. the underlying

surface‘s deviation from absolute level, in both

positions (0° and 180°).

Make sure that the reference function

is deactivated before measuring.