Hermes Technics HT-EK110L [14/22] English

ENGLISH

OPERATION

BEFORE USING YOUR KETTLE. If you are using the kettle for the first time, it is

recommended that you should clean your kettle before use by boiling a full kettle

of water twice and then discarding the water. Wipe the surface with a damp cloth.

NOTE: the max capacity of kettle is 1.2 L.

1. To fill the kettle, remove it from the power base and open the lid, fill with the

desired amount of water, and then close the lid. Alternatively, the kettle may be

filled through the spout. The water level should not exceed MAX marks or sit

below MIN level. Too little water will result in the kettle switching off before the

water has boiled.

NOTE: Do not fill the water over the maximum level, as water may spill out of the

spout when boiling. Ensure that the lid is firmly in place before plugging the power

outlet.

2. Position the kettle on the power base.

3. Connect the plug into a power outlet. Turn on the switch by pressing it, the

indicator will light up. Then start to boil the water, the kettle will switch off

automatically once the water has boiled. You can shut off the power by turning

off the switch at any moment during boiling water. If you want to boil water

again, only turn on the switch directly to restart the kettle.

NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the

kettle will not turn off if the switch is constrained or if the lid is opening.

4. Lift the kettle from the power base and then pour the water.

NOTE: operate carefully when pouring the water from your kettle, as boiling water

will scald.

5. The kettle will not re‑boil until the switch is pressed again. The kettle may be

stored on the power base when not in use.

NOTE: always disconnect the power supply when not use.

WARNING: Do not remove the lid white the water is boiling.

CAUTION: Position the lid so that steam is directed away from the handle.

ENGLISH