Qtech QSW-2910-28F-AC [134/212] Sntp client working mode configuration

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

134

sntp client

no sntp client

For example:

!Enable SNTP client

QTECH(config)#sntp client

10.2.2 SNTP client working mode configuration

SNTPv4 can work in three modes: unicast, broadcast (multicast), anycast. In unicast and

anycast, client sends requirement and gets the response to adjust system time. In broadcast

and multicast, client waits for the broadcast packet sent by server to adjust system time.

sntp client mode { broadcast | unicast | anycast [ key number ] | multicast }

no sntp client mode

For example:

!Configure SNTP client to operate in anycast

QTECH(config)#sntp client mode anycast

10.2.3 SNTP client unicast server configuration

In unicast ode, SNTP client must configure server address. The related command is as

following:

sntp server ip-address [ key number ]

no sntp server

Only in unicast, configured server address can be effective.

For example:

!Configure unicast server ip-address to be 192.168.0.100

QTECH(config)#sntp server 192.168.0.100

10.2.4 SNTP client broadcast delay configuration

SNTP client broadcast delay configuration is as following:

sntp client broadcastdelay milliseconds

no sntp client broadcastdelay

Only in broadcast (multicast), configured transmit delay can be effective. After configuration,

SNTP client can add transmit delay after obtaining time from server to adjust current system

time.