Qtech QSW-3200-28T [35/146] Interface shutdown control configuration

+7(495) 797-3311www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

Port alarm normal threshold(Mbps) : 60

Total entries: 1.0

2.7 Interface shutdown-control Configuration

2.7.1 Brief introduction of shutdown-control

Interface shutdown-control is used to restrict the speed rate of unicast\ multicast\broadcast of

single interface. If the rate is beyond the configured restricted value (that can be configured), the

interface will be shut down and failure trap will be sent. After a while (it is defaulted to be 480

seconds, which can be configured), it may reopen. If the interface will not reshutdown-control in

2 seconds, it turns normal and normal trap will be sent. If the interface reshutdown-control in 2

seconds, the failure trap will not be sent.

2.7.2 Interface shutdown-control Configuration list

Interface shutdown-control Configuration list is as following:

 shutdown-control Configuration

 Configure shutdown-control open-time

 Display shutdown-control

 Recover shutdown-control

2.7.3 shutdown-control Configuration

Configure it in interface configuration mode:

 Enable shutdown-control

 shutdown-control [ broadcast | multicast | unicast ] target-rate

 Disable shutdown-control

no shutdown-control [ broadcast | multicast | unicast ]

By default, shutdown-control is disabled.

Example:

! Enable shutdown-control of e0/8 for broadcast and speed rate is 100pps.

QTECH(config-if-ethernet-0/8)#shutdown-control broadcast 100

2.7.4 Configure shutdown-control open-time

Configure it in global configuration mode:

 Configure shutdown-control open-time

shutdown-control-open-time

The default shutdown-control open-time is 480 seconds.

Example:

! Configure shutdown-control-open-time of CAR is 20 seconds

QTECH(config)# shutdown-control-open-time 20

2.7.5 Display shutdown-control

 Configure it in any configuration mode:

show shutdown-control interface