Qtech QSW-8200-52T-AC — настройка протокола IPv6 Multicast: руководство пользователя [24/39]

Превью страниц Страница 24 / 39

User Manual

Chapter 2. IPv6 Multicast Protocol 24

www.qtech.ru

 Function: Configure IPv6 destination control multicast access list, the no operation of

this command is used to delete the access list.

 Parameters: <9000-10999>: The source control access list number.

 {deny|permit}: Deny or permit.

 <source/M>: The multicast source address and the length of mask.

 <source-host-ip>: Multicast source host address.

 <destination/M>: Multicast destination address and the length of mask.

 <destination-host-ip>: Multicast destination host address.

 Default: None.

 Command Mode: Global Configuration Mode.

 Usage Guide: IPv6 multicast destination control entries control the ACL it uses with ACL

number 9000-10999, this command is used to configure such ACL. IPv6 multicast source

control ACL only needs to configure the source IPv6 address and destination IPv6

address (that is the group IPV6 addresses) , the configuration adopts a method similar

to other ACLs, which can either be a address range configured by the length of mask, or

a specified host address or all addresses Which are to be controlled. Pay attention to

that, for group IPV6 addresses, the “all addresses” mentioned here is ff:/8.

 Example:

 Switch(config)#ipv6 access-list 9000 permit fe80::203:228a/64 ff1e::1/64

2.1.3 ipv6 multicast destination-control access-group

 Command: ipv6 multicast destination-control access-group <9000-10999>

 no ipv6 multicast destination-control access-group <9000-10999>

 Function: Configure the IPv6 multicast destination control access list used by the port,

the no operation of the command will delete this configuration.

 Parameters: <9000-10999>: The destination control access list number.

 Default: Not configured.

 Command Mode: Port Configuration Mode.

 Usage Guide: This command can only take effect when the IPv6 multicast destination

control is globally enabled, after configuring this command, if the MLD-SNOOPING is

enabled, when adding the port to the multicast group, it will be matched according to

the configured access list. Only when the port is matched as permit, will it be added, or

it can not be added.

 Example:

 switch(config)#inter ethernet 1/0/4

 switch(Config-If-Ethernet1/0/4)#ipv6 multicast destination-control access-group 9000

 switch(Config-If-Ethernet1/0/4)#

2.1.4 ipv6 multicast destination-control access-group (sip)

 Command: ipv6 multicast destination-control <IPADDRESS/M> access-group <9000-

10999>