Qtech QSW-8200-52T-AC Команды настройки vlan онлайн [22/41] 481623

User Manual

Chapter 1. VLAN Configuration 22

www.qtech.ru

 Usage Guide: Set 1006 as the default internal VLAN ID, the internal VLAN ID needs to

be modified when the network set 1006 as VLAN ID. Internal VLAN ID must select an

unused ID or else affect other VLAN. This command takes effect after save the

configuration and reboot the switch.

 Example: Set 100 as the internal VLAN ID.

 Switch(config)#vlan 100 internal

1.1.40 vlan ingress enable

 Command: vlan ingress enable

 no vlan ingress enable

 Function: Enable the VLAN ingress filtering for a port; the “no vlan ingress enable”

command disables the ingress filtering.

 Command mode: Port Mode

 Default: Enable VLAN ingress filtering function.

 Usage Guide: After VLAN ingress filtering is enabled on the port, when the system

receives data it will check source port first, and forwards the data to the destination

port if it is the VLAN member port, or else drop the data.

 Example: Disable VLAN ingress rules on the port.

 Switch(Config-If-Ethernet1/0/1)# no vlan ingress enable

1.1.41 vlan-translation

 Command: vlan-translation <old-vlan-id> to <new-vlan-id>{in | out}

 no vlan-translation <old-vlan-id>{in | out}

 Function: Add VLAN translation by creating a mapping between original VLAN ID and

current VLAN ID; the no form of this command deletes corresponding mapping.

 Parameter: old-vlan-id is the original VLAN ID; new-vlan-id is the translated VLAN ID; in

indicates ingress translation; out indicates egress translation.

 Command Mode: Port Mode.

 Default: There is no VLAN translation relation.

 Usage Guide: The command is for configuring the in and out translation relation of the

VLAN translation function. The data packets will be matched according to the

configured translation relations, and its VLAN ID will be changed to the one in the

configured item once matched, while the vlan-translation miss drop command will

determine the next forwarding if not match.

 The access ports of the switch can not support this function.

 Example: Move the VLAN100 data entered from the port1 to VLAN2 after ingress

translation.

 Switch#config

 Switch(config)#interface ethernet 1/0/1

 Switch(Config-If-Ethernet1/0/1)#vlan-translation enable

 Switch(Config-If-Ethernet1/0/1)#vlan-translation 100 to 2 in

 Switch(Config-If-Ethernet1/0/1)#exit