Qtech QSW-8200-52T-POEAC- DC Команды для poe онлайн [6/10] 481625

User Manual

Chapter 1. Commands for PoE 6

www.qtech.ru

 Command Mode: Port Mode.

 Default: The max output power of a port is 15400mW (802.3af)/3000mW (802.3at).

 Usage Guide: This configuration will effectively control the output power of each port

in cooperation with the global max power.

 Example: Set the max output power of Port 1 to 0.8W.

 Switch(Config)#interface ethernet 1/0/1

 Switch(Config-Ethernet1/0/1)#power inline max 800

1.1.9 power inline police

 Command: power inline police enable

 no power inline police enable

 Function: Enable/disable the power priority management policy mode.

 Parameters: None.

 Command Mode: Global Mode.

 Default:The power priority management policy mode is disabled.

 Usage Guide: Decide whether to use priority policy in power management policy. The

“enable” command will make priority policy in effect, while “no” command will recover

the first-come-first-served policy. With priority policy enabled, port priority can be

configured individually.

 In priority mode, when not enough PSE power is available, ports with low priority will

be closed to satisfy the power supply for ports with high priority, no matter how long

the access time of a PD is. If two ports have same priority, the one with smaller

sequence number is higher privileged.

 In first-come-first-served mode, new PDs will not get power supply if available PSE

power is not enough.

 Example: Enable the power priority policy mode.

 Switch(Config)#power inline police enable

1.1.10 power inline priority

 Command: power inline priority {critical | high | low}

 Function: Set power supply priority of a port.

 Parameters: critical: the highest-level priority. high: high-level priority. low: low-level

priority.

 Command Mode: Port Mode.

 Default: Port priority is low.

 Usage Guide: This command will take effect in the mode of “power inline police

enable”. Without enough available power for newly connected PD, ports with higher

priority will get power supply first.

 Examples: Set the priority of Port 1 to high and that of Port 2 to critical.

 Switch(Config)#interface ethernet 1/0/1

 Switch(Config-Ethernet1/0/1)#power inline priority high

 Switch(Config)#interface ethernet 1/0/2