Qtech QSW-8200-28T-AC — настройка VLAN и таймеров GARP: Руководство пользователя [7/41]

Превью страниц Страница 7 / 41

User Manual

Chapter 1. VLAN Configuration 7

www.qtech.ru

 Command: dot1q-tunnel tpid {0x8100|0x9100|0x9200| <1-65535> }

 Function: Configure the type (TPID) of the protocol of switch trunk port.

 Parameter: None.

 Command Mode: Port Mode.

 Default: TPID on the port is defaulted at 0x8100.

 Usage Guide: This function is to facilitate internetworking with equipments of other

manufacturers. If the equipment connected with the switch trunk port sends data

packet with a TPID of 0x9100, the port TPID will be set to 0x9100, this way switch will

receive and process data packets normally. This command and dot1q-tunnel enable are

mutually exclusive.

 Example: Set port 10 of the switch to trunk port and sends data packet with a TPID of 0x9100.

 Switch(config)#interface ethernet 1/0/10

 Switch(Config-If-Ethernet1/0/10)#switchport mode trunk

 Switch(Config-If-Ethernet1/0/10)#dot1q-tunnel tpid 0x9100

 Switch(Config-If-Ethernet1/0/10)#exit

 Switch(config)#

1.1.8 garp timer join

 Command: garp timer join <200-500>

 Function: Set the value of garp join timer, note that the value of join timer must be less

than half leave timer.

 Parameters: <200-500>, the value of timer in millisecond

 Command Mode: Global mode

 Default: 200 ms.

 Usage Guide: Check whether the value satisfy the range. If so, modify the value of garp

timer to the specified value, otherwise return a configuration error.

 Example: Set the value of garp join timer as 200ms.

 Switch(config)#garp timer join 200

1.1.9 garp timer leave

 Command: garp timer leave <500-1200>

 Function: Set the value of garp leave timer, note that the value of leave timer must be

double of join timer and less than leaveAll timer.

 Parameters: <500-1200>, the value of timer in millisecond

 Command Mode: Global mode

 Default: 600 ms.

 Usage Guide: Check whether the value satisfy the range. If so, modify the value of garp

timer to the specified value, otherwise return a configuration error.

 Example: Set the value of garp leave timer as 600ms.

 Switch(config)#garp timer leave 600